[EXT] Re: [PATCH v6 4/5] dts: marvell: Enable 10G interfaces on 9130-DB and 9131-DB boards

[Stefan Chulski]

> External Email
> 
> ----------------------------------------------------------------------
> On Thu, Jul 08, 2021 at 02:25:27PM +0300, kostap at marvell.com wrote:
> > From: Stefan Chulski <stefanc at marvell.com>
> >
> > This patch enables eth0 10G interface on CN9130-DB paltforms and
> > eth0 10G and eth3 10G interfaces on CN9131-DB.
> >
> > Signed-off-by: Stefan Chulski <stefanc at marvell.com>
> > Signed-off-by: Konstantin Porotchkin <kostap at marvell.com>
> > ---
> >  arch/arm64/boot/dts/marvell/cn9130-db.dtsi | 2 +-
> > arch/arm64/boot/dts/marvell/cn9131-db.dtsi | 2 +-
> >  2 files changed, 2 insertions(+), 2 deletions(-)
> >
> > diff --git a/arch/arm64/boot/dts/marvell/cn9130-db.dtsi
> > b/arch/arm64/boot/dts/marvell/cn9130-db.dtsi
> > index 34274e061958..39fc90716454 100644
> > --- a/arch/arm64/boot/dts/marvell/cn9130-db.dtsi
> > +++ b/arch/arm64/boot/dts/marvell/cn9130-db.dtsi
> > @@ -125,7 +125,7 @@
> >
> >  /* SLM-1521-V2, CON9 */
> >  &cp0_eth0 {
> > -	status = "disabled";
> > +	status = "okay";
> >  	phy-mode = "10gbase-kr";
> 
> Are these really 10gbase-kr? Or should this be 10gbase-r ?

Should be 10gbase-r. By default we do not support full KR protocol.

Regards.