[PATCH phy v2 3/6] arm64: dts: marvell: armada-37xx: Add xtal clock to comphy node

[Gregory CLEMENT]

Marek Behún <kabel at kernel.org> writes:

> From: Pali Rohár <pali at kernel.org>
>
> Kernel driver phy-mvebu-a3700-comphy.c needs to know the rate of the
> reference xtal clock. So add missing xtal clock source into comphy device
> tree node. If the property is not present, the driver defaults to 25 MHz
> xtal rate (which, as far as we know, is used by all the existing boards).
>
> Signed-off-by: Pali Rohár <pali at kernel.org>
> Signed-off-by: Marek Behún <kabel at kernel.org>

Applied on mvebu/dt64

Thanks,

Gregory

> ---
>  arch/arm64/boot/dts/marvell/armada-37xx.dtsi | 2 ++
>  1 file changed, 2 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/marvell/armada-37xx.dtsi b/arch/arm64/boot/dts/marvell/armada-37xx.dtsi
> index 9acc5d2b5a00..673f4906eef9 100644
> --- a/arch/arm64/boot/dts/marvell/armada-37xx.dtsi
> +++ b/arch/arm64/boot/dts/marvell/armada-37xx.dtsi
> @@ -265,6 +265,8 @@ comphy: phy at 18300 {
>  					    "lane2_sata_usb3";
>  				#address-cells = <1>;
>  				#size-cells = <0>;
> +				clocks = <&xtalclk>;
> +				clock-names = "xtal";
>  
>  				comphy0: phy at 0 {
>  					reg = <0>;
> -- 
> 2.32.0
>

-- 
Gregory Clement, Bootlin
Embedded Linux and Kernel engineering
http://bootlin.com