[PATCHv3 1/6] ARM: dts: meson8b: odroidc1: Add usb phy power node

[Martin Blumenstingl]

Hi Anand,

sorry for the late reply
I have three very small comments below, apart from these, this is looking good!

On Tue, Aug 17, 2021 at 6:17 AM Anand Moon <linux.amoon at gmail.com> wrote:
>
> Add missing usb phy power node for usb node fix below warning.
> P5V0 regulator supply input voltage range to USB host controller.
> As described in the C1+ schematics, GPIO GPIOAO_5 is used to
> enable input power to USB ports, set it to Active Low.
I would phrase this last sentence as:
"enable USB VBUS on the Micro-USB port using an active high signal"
My idea here is to 1) clarify that it's about enabling USB VBUS only
on the Micro-USB port and 2) use "active high" like the changes inside
the patch itself

> [    1.260772] dwc2 c90c0000.usb: Looking up vbus-supply from device tree
> [    1.260784] dwc2 c90c0000.usb: Looking up vbus-supply property in
>                 mode /soc/usb at c90c0000 failed
>
> Fixes: 2eb79a4d15ff (ARM: dts: meson: enabling the USB Host
>                 controller on Odroid-C1/C1+ board)
>
please drop this empty line

[...]
> @@ -119,7 +136,6 @@ vcc_3v3: regulator-vcc-3v3 {
>                 regulator-name = "VCC3V3";
>                 regulator-min-microvolt = <3300000>;
>                 regulator-max-microvolt = <3300000>;
> -
I don't think that we should make any VCC3V3 regulator changes in this patch
so please keep this empty line as-is.


Best regards,
Martin