[PATCH 03/10] ata: at91: use syscon to configure the smc
Alexandre Belloni
alexandre.belloni at free-electrons.com
Mon Mar 16 15:44:39 PDT 2015
Use syscon/regmap to configure the smc. This allows to avoid using
at91sam9_smc.h and to compile the driver in a multiplatform configuration.
The driver will still not probe until the proper DT bindings are added.
Signed-off-by: Alexandre Belloni <alexandre.belloni at free-electrons.com>
---
drivers/ata/Kconfig | 1 -
drivers/ata/pata_at91.c | 92 ++++++++++++++++++++++++++++++++++++++-----------
2 files changed, 71 insertions(+), 22 deletions(-)
diff --git a/drivers/ata/Kconfig b/drivers/ata/Kconfig
index 5f601553b9b0..a3a13605a9c4 100644
--- a/drivers/ata/Kconfig
+++ b/drivers/ata/Kconfig
@@ -835,7 +835,6 @@ config PATA_AT32
config PATA_AT91
tristate "PATA support for AT91SAM9260"
depends on ARM && SOC_AT91SAM9
- depends on !ARCH_MULTIPLATFORM
help
This option enables support for IDE devices on the Atmel AT91SAM9260 SoC.
diff --git a/drivers/ata/pata_at91.c b/drivers/ata/pata_at91.c
index 9e85937d36a9..ace0a4de3449 100644
--- a/drivers/ata/pata_at91.c
+++ b/drivers/ata/pata_at91.c
@@ -24,11 +24,13 @@
#include <linux/ata.h>
#include <linux/clk.h>
#include <linux/libata.h>
+#include <linux/mfd/syscon.h>
+#include <linux/mfd/syscon/atmel-smc.h>
#include <linux/platform_device.h>
#include <linux/ata_platform.h>
#include <linux/platform_data/atmel.h>
+#include <linux/regmap.h>
-#include <mach/at91sam9_smc.h>
#include <asm/gpio.h>
#define DRV_NAME "pata_at91"
@@ -57,6 +59,15 @@ struct smc_range {
int max;
};
+struct regmap *smc;
+
+struct at91sam9_smc_generic_fields {
+ struct regmap_field *setup;
+ struct regmap_field *pulse;
+ struct regmap_field *cycle;
+ struct regmap_field *mode;
+} fields;
+
/**
* adjust_smc_value - adjust value for one of SMC registers.
* @value: adjusted value
@@ -206,7 +217,6 @@ static void set_smc_timing(struct device *dev, struct ata_device *adev,
{
int ret = 0;
int use_iordy;
- struct sam9_smc_config smc;
unsigned int t6z; /* data tristate time in ns */
unsigned int cycle; /* SMC Cycle width in MCK ticks */
unsigned int setup; /* SMC Setup width in MCK ticks */
@@ -244,19 +254,21 @@ static void set_smc_timing(struct device *dev, struct ata_device *adev,
dev_dbg(dev, "Use IORDY=%u, TDF Cycles=%u\n", use_iordy, tdf_cycles);
- /* SMC Setup Register */
- smc.nwe_setup = smc.nrd_setup = setup;
- smc.ncs_write_setup = smc.ncs_read_setup = 0;
- /* SMC Pulse Register */
- smc.nwe_pulse = smc.nrd_pulse = pulse;
- smc.ncs_write_pulse = smc.ncs_read_pulse = cs_pulse;
- /* SMC Cycle Register */
- smc.write_cycle = smc.read_cycle = cycle;
- /* SMC Mode Register*/
- smc.tdf_cycles = tdf_cycles;
- smc.mode = info->mode;
-
- sam9_smc_configure(0, info->cs, &smc);
+ regmap_fields_write(fields.setup, info->cs,
+ AT91SAM9_SMC_NRDSETUP(setup) |
+ AT91SAM9_SMC_NWESETUP(setup) |
+ AT91SAM9_SMC_NCS_NRDSETUP(0) |
+ AT91SAM9_SMC_NCS_WRSETUP(0));
+ regmap_fields_write(fields.pulse, info->cs,
+ AT91SAM9_SMC_NRDPULSE(pulse) |
+ AT91SAM9_SMC_NWEPULSE(pulse) |
+ AT91SAM9_SMC_NCS_NRDPULSE(cs_pulse) |
+ AT91SAM9_SMC_NCS_WRPULSE(cs_pulse));
+ regmap_fields_write(fields.cycle, info->cs,
+ AT91SAM9_SMC_NRDCYCLE(cycle) |
+ AT91SAM9_SMC_NWECYCLE(cycle));
+ regmap_fields_write(fields.mode, info->cs, info->mode |
+ AT91_SMC_TDF_(tdf_cycles));
}
static void pata_at91_set_piomode(struct ata_port *ap, struct ata_device *adev)
@@ -280,21 +292,21 @@ static unsigned int pata_at91_data_xfer_noirq(struct ata_device *dev,
{
struct at91_ide_info *info = dev->link->ap->host->private_data;
unsigned int consumed;
+ unsigned int mode;
unsigned long flags;
- struct sam9_smc_config smc;
local_irq_save(flags);
- sam9_smc_read_mode(0, info->cs, &smc);
+ regmap_fields_read(fields.mode, info->cs, &mode);
/* set 16bit mode before writing data */
- smc.mode = (smc.mode & ~AT91_SMC_DBW) | AT91_SMC_DBW_16;
- sam9_smc_write_mode(0, info->cs, &smc);
+ regmap_fields_write(fields.mode, info->cs, (mode & ~AT91_SMC_DBW) |
+ AT91_SMC_DBW_16);
consumed = ata_sff_data_xfer(dev, buf, buflen, rw);
/* restore 8bit mode after data is written */
- smc.mode = (smc.mode & ~AT91_SMC_DBW) | AT91_SMC_DBW_8;
- sam9_smc_write_mode(0, info->cs, &smc);
+ regmap_fields_write(fields.mode, info->cs, (mode & ~AT91_SMC_DBW) |
+ AT91_SMC_DBW_8);
local_irq_restore(flags);
return consumed;
@@ -312,6 +324,36 @@ static struct ata_port_operations pata_at91_port_ops = {
.cable_detect = ata_cable_40wire,
};
+static int at91sam9_smc_fields_init(struct device *dev)
+{
+ struct reg_field field = REG_FIELD(0, 0, 31);
+
+ field.id_size = 8;
+ field.id_offset = AT91SAM9_SMC_GENERIC_BLK_SZ;
+
+ field.reg = AT91SAM9_SMC_SETUP(AT91SAM9_SMC_GENERIC);
+ fields.setup = devm_regmap_field_alloc(dev, smc, field);
+ if (IS_ERR(fields.setup))
+ return PTR_ERR(fields.setup);
+
+ field.reg = AT91SAM9_SMC_PULSE(AT91SAM9_SMC_GENERIC);
+ fields.pulse = devm_regmap_field_alloc(dev, smc, field);
+ if (IS_ERR(fields.pulse))
+ return PTR_ERR(fields.pulse);
+
+ field.reg = AT91SAM9_SMC_CYCLE(AT91SAM9_SMC_GENERIC);
+ fields.cycle = devm_regmap_field_alloc(dev, smc, field);
+ if (IS_ERR(fields.cycle))
+ return PTR_ERR(fields.cycle);
+
+ field.reg = AT91SAM9_SMC_MODE(AT91SAM9_SMC_GENERIC);
+ fields.mode = devm_regmap_field_alloc(dev, smc, field);
+ if (IS_ERR(fields.mode))
+ return PTR_ERR(fields.mode);
+
+ return 0;
+}
+
static int pata_at91_probe(struct platform_device *pdev)
{
struct at91_cf_data *board = dev_get_platdata(&pdev->dev);
@@ -341,6 +383,14 @@ static int pata_at91_probe(struct platform_device *pdev)
irq = board->irq_pin;
+ smc = syscon_regmap_lookup_by_phandle(pdev->dev.of_node, "atmel,smc");
+ if (IS_ERR(smc))
+ return PTR_ERR(smc);
+
+ ret = at91sam9_smc_fields_init(dev);
+ if (ret < 0)
+ return ret;
+
/* init ata host */
host = ata_host_alloc(dev, 1);
--
2.1.0
More information about the linux-pcmcia
mailing list