[PATCH v2 1/9] ata: at91: use syscon to configure the smc
Bartlomiej Zolnierkiewicz
b.zolnierkie at samsung.com
Wed Apr 8 04:04:19 PDT 2015
Hi,
On Monday, March 23, 2015 08:29:07 PM Alexandre Belloni wrote:
> Use syscon/regmap to configure the smc. This allows to avoid using
> at91sam9_smc.h and to compile the driver in a multiplatform configuration.
>
> The driver will still not probe until the proper DT bindings are added. That
> binding will include an atmel,smc property that is a phandle to the SMC the CF
> controller is connected to.
If the driver is currently working fine in !ARCH_MULTIPLATFORM
configuration then this patch will make it non-functional until
atmel,smc property is added to DT. To prevent this and preserve
bisectability the patchset should first add atmel,smc property
and then convert pata_at91 driver to use it.
Best regards,
--
Bartlomiej Zolnierkiewicz
Samsung R&D Institute Poland
Samsung Electronics
> Signed-off-by: Alexandre Belloni <alexandre.belloni at free-electrons.com>
> ---
> drivers/ata/Kconfig | 1 -
> drivers/ata/pata_at91.c | 92 ++++++++++++++++++++++++++++++++++++++-----------
> 2 files changed, 71 insertions(+), 22 deletions(-)
>
> diff --git a/drivers/ata/Kconfig b/drivers/ata/Kconfig
> index 5f601553b9b0..a3a13605a9c4 100644
> --- a/drivers/ata/Kconfig
> +++ b/drivers/ata/Kconfig
> @@ -835,7 +835,6 @@ config PATA_AT32
> config PATA_AT91
> tristate "PATA support for AT91SAM9260"
> depends on ARM && SOC_AT91SAM9
> - depends on !ARCH_MULTIPLATFORM
> help
> This option enables support for IDE devices on the Atmel AT91SAM9260 SoC.
>
> diff --git a/drivers/ata/pata_at91.c b/drivers/ata/pata_at91.c
> index 9e85937d36a9..ace0a4de3449 100644
> --- a/drivers/ata/pata_at91.c
> +++ b/drivers/ata/pata_at91.c
> @@ -24,11 +24,13 @@
> #include <linux/ata.h>
> #include <linux/clk.h>
> #include <linux/libata.h>
> +#include <linux/mfd/syscon.h>
> +#include <linux/mfd/syscon/atmel-smc.h>
> #include <linux/platform_device.h>
> #include <linux/ata_platform.h>
> #include <linux/platform_data/atmel.h>
> +#include <linux/regmap.h>
>
> -#include <mach/at91sam9_smc.h>
> #include <asm/gpio.h>
>
> #define DRV_NAME "pata_at91"
> @@ -57,6 +59,15 @@ struct smc_range {
> int max;
> };
>
> +struct regmap *smc;
> +
> +struct at91sam9_smc_generic_fields {
> + struct regmap_field *setup;
> + struct regmap_field *pulse;
> + struct regmap_field *cycle;
> + struct regmap_field *mode;
> +} fields;
> +
> /**
> * adjust_smc_value - adjust value for one of SMC registers.
> * @value: adjusted value
> @@ -206,7 +217,6 @@ static void set_smc_timing(struct device *dev, struct ata_device *adev,
> {
> int ret = 0;
> int use_iordy;
> - struct sam9_smc_config smc;
> unsigned int t6z; /* data tristate time in ns */
> unsigned int cycle; /* SMC Cycle width in MCK ticks */
> unsigned int setup; /* SMC Setup width in MCK ticks */
> @@ -244,19 +254,21 @@ static void set_smc_timing(struct device *dev, struct ata_device *adev,
>
> dev_dbg(dev, "Use IORDY=%u, TDF Cycles=%u\n", use_iordy, tdf_cycles);
>
> - /* SMC Setup Register */
> - smc.nwe_setup = smc.nrd_setup = setup;
> - smc.ncs_write_setup = smc.ncs_read_setup = 0;
> - /* SMC Pulse Register */
> - smc.nwe_pulse = smc.nrd_pulse = pulse;
> - smc.ncs_write_pulse = smc.ncs_read_pulse = cs_pulse;
> - /* SMC Cycle Register */
> - smc.write_cycle = smc.read_cycle = cycle;
> - /* SMC Mode Register*/
> - smc.tdf_cycles = tdf_cycles;
> - smc.mode = info->mode;
> -
> - sam9_smc_configure(0, info->cs, &smc);
> + regmap_fields_write(fields.setup, info->cs,
> + AT91SAM9_SMC_NRDSETUP(setup) |
> + AT91SAM9_SMC_NWESETUP(setup) |
> + AT91SAM9_SMC_NCS_NRDSETUP(0) |
> + AT91SAM9_SMC_NCS_WRSETUP(0));
> + regmap_fields_write(fields.pulse, info->cs,
> + AT91SAM9_SMC_NRDPULSE(pulse) |
> + AT91SAM9_SMC_NWEPULSE(pulse) |
> + AT91SAM9_SMC_NCS_NRDPULSE(cs_pulse) |
> + AT91SAM9_SMC_NCS_WRPULSE(cs_pulse));
> + regmap_fields_write(fields.cycle, info->cs,
> + AT91SAM9_SMC_NRDCYCLE(cycle) |
> + AT91SAM9_SMC_NWECYCLE(cycle));
> + regmap_fields_write(fields.mode, info->cs, info->mode |
> + AT91_SMC_TDF_(tdf_cycles));
> }
>
> static void pata_at91_set_piomode(struct ata_port *ap, struct ata_device *adev)
> @@ -280,21 +292,21 @@ static unsigned int pata_at91_data_xfer_noirq(struct ata_device *dev,
> {
> struct at91_ide_info *info = dev->link->ap->host->private_data;
> unsigned int consumed;
> + unsigned int mode;
> unsigned long flags;
> - struct sam9_smc_config smc;
>
> local_irq_save(flags);
> - sam9_smc_read_mode(0, info->cs, &smc);
> + regmap_fields_read(fields.mode, info->cs, &mode);
>
> /* set 16bit mode before writing data */
> - smc.mode = (smc.mode & ~AT91_SMC_DBW) | AT91_SMC_DBW_16;
> - sam9_smc_write_mode(0, info->cs, &smc);
> + regmap_fields_write(fields.mode, info->cs, (mode & ~AT91_SMC_DBW) |
> + AT91_SMC_DBW_16);
>
> consumed = ata_sff_data_xfer(dev, buf, buflen, rw);
>
> /* restore 8bit mode after data is written */
> - smc.mode = (smc.mode & ~AT91_SMC_DBW) | AT91_SMC_DBW_8;
> - sam9_smc_write_mode(0, info->cs, &smc);
> + regmap_fields_write(fields.mode, info->cs, (mode & ~AT91_SMC_DBW) |
> + AT91_SMC_DBW_8);
>
> local_irq_restore(flags);
> return consumed;
> @@ -312,6 +324,36 @@ static struct ata_port_operations pata_at91_port_ops = {
> .cable_detect = ata_cable_40wire,
> };
>
> +static int at91sam9_smc_fields_init(struct device *dev)
> +{
> + struct reg_field field = REG_FIELD(0, 0, 31);
> +
> + field.id_size = 8;
> + field.id_offset = AT91SAM9_SMC_GENERIC_BLK_SZ;
> +
> + field.reg = AT91SAM9_SMC_SETUP(AT91SAM9_SMC_GENERIC);
> + fields.setup = devm_regmap_field_alloc(dev, smc, field);
> + if (IS_ERR(fields.setup))
> + return PTR_ERR(fields.setup);
> +
> + field.reg = AT91SAM9_SMC_PULSE(AT91SAM9_SMC_GENERIC);
> + fields.pulse = devm_regmap_field_alloc(dev, smc, field);
> + if (IS_ERR(fields.pulse))
> + return PTR_ERR(fields.pulse);
> +
> + field.reg = AT91SAM9_SMC_CYCLE(AT91SAM9_SMC_GENERIC);
> + fields.cycle = devm_regmap_field_alloc(dev, smc, field);
> + if (IS_ERR(fields.cycle))
> + return PTR_ERR(fields.cycle);
> +
> + field.reg = AT91SAM9_SMC_MODE(AT91SAM9_SMC_GENERIC);
> + fields.mode = devm_regmap_field_alloc(dev, smc, field);
> + if (IS_ERR(fields.mode))
> + return PTR_ERR(fields.mode);
> +
> + return 0;
> +}
> +
> static int pata_at91_probe(struct platform_device *pdev)
> {
> struct at91_cf_data *board = dev_get_platdata(&pdev->dev);
> @@ -341,6 +383,14 @@ static int pata_at91_probe(struct platform_device *pdev)
>
> irq = board->irq_pin;
>
> + smc = syscon_regmap_lookup_by_phandle(pdev->dev.of_node, "atmel,smc");
> + if (IS_ERR(smc))
> + return PTR_ERR(smc);
> +
> + ret = at91sam9_smc_fields_init(dev);
> + if (ret < 0)
> + return ret;
> +
> /* init ata host */
>
> host = ata_host_alloc(dev, 1);
More information about the linux-pcmcia
mailing list