[PATCH 11/18] pcmcia: do not use io_req_t when calling pcmcia_request_io()

[Komuro]

Hi,

>Also on re-inserting the card (with 2.6.36-rc4+ as of today)?

I tried the 2.6.36-rc4-git4.
The serial part still does not work,  before and after re-inserting the card.



>elese we wouldn't see the "is a 16550A" message, right?

Even if the COR(Configuration Option Register) of irq is not properly setup,
we can see the above message...


>Hey,
>
>On Sat, Sep 18, 2010 at 07:20:31PM +0900, Komuro wrote:
>> With this patch, fmvj18x_cs based card works (both network and serial).
>
>good. Will push the patch upstream, then.
>
>> but Serial part of Xircom card still does not work.
>
>Also on re-inserting the card (with 2.6.36-rc4+ as of today)?
>
>> I think the reason is irq or io_width or io_lines is not setuped properly
>> for Xircom-card by pcmcia_core.
>
>But those values are the same for 2.6.35 and 2.6.36-rc4+, else we wouldn't
>see the same 
>
>eth0: Xircom: port 0x300, irq 18, hwaddr 00:10:a4:f3:db:02
>0.1: ttyS3 at I/O 0x2e8 (irq = 18) is a 16550A
>
>messages. Furthermore, at least some access to the serial part does work,
>elese we wouldn't see the "is a 16550A" message, right?
>
>Best,
>	Dominik