[RFC] [PATCH] pcmcia/yenta ti113x route irq to isa

Dominik Brodowski linux at dominikbrodowski.net
Sat Mar 6 02:33:36 EST 2010


On Thu, Mar 04, 2010 at 09:28:41AM +0100, Jens Künzer wrote:
> Resubmitting this with hopefully proper signoff:
> 
> This is a patch for a old IBM Thinkpad 760ED notebook.
> 
> The pci irq pin of the ti1130 pcmcia bridge is not connected.
> To use the cardbus, the irq has to be routed to an isa irq.
> This patch detects an valid irq and route cardbus interupts to isa instead of pci.
> (If a valid pci irq is detected it should use it and not the isa irq.)
> 
> I have tested it in my laptop only. I tested a ethernet and a usb cardbus card. Both OK
> I also inserted but don't realy used a old pcmcia modem card. It detected the irq correct.
> 
> Maybe some of you can test this patch on other hardware.
> And please review the changes, especially those in yenta_socket.c
> I am not sure about these changes not breaking other ti pcmcia bridges.
> 
>        Signed-off-by: Jens Kuenzer <Jens.Kuenzer at fpga.homeip.net>

Many thanks! I've split it up into three parts and only made a few cleanups.
It would be great if you (and others) could check those out.

Best,
	Dominik



More information about the linux-pcmcia mailing list