[Bug 24712] PCMCIA card insert not detected after resume

[bugzilla-daemon at bugzilla.kernel.org]

https://bugzilla.kernel.org/show_bug.cgi?id=24712





--- Comment #2 from Filip Pytloun <kenji at ifrit.eu>  2010-12-12 12:18:37 ---
(In reply to comment #1)
> What's the output of "lspcmcia -vvv" before suspend, with the card inserted?

$ lspcmcia -vvv
Socket 0 Bridge:       [yenta_cardbus]     (bus ID: 0000:15:00.0)
    Configuration:    state: on    ready: unknown
--none--
--none--

This is strange, because the card is inserted and running well.
Pccardctl shows no card.

$ pccardctl status
Socket 0:
  no card

I can still propertly eject and insert the card and it will work ok. It will
fail just after the resume from suspend.

Here is the lspci -vvv output for the card itself:

05:00.0 USB Controller: NEC Corporation uPD720200 USB 3.0 Host Controller (rev
03) (prog-if 30)
        Subsystem: NEC Corporation uPD720200 USB 3.0 Host Controller
        Physical Slot: 3
        Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B- DisINTx+
        Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort-
<MAbort- >SERR- <PERR- INTx-
        Latency: 0, Cache Line Size: 64 bytes
        Interrupt: pin A routed to IRQ 19
        Region 0: Memory at f8000000 (64-bit, non-prefetchable) [size=8K]
        Capabilities: <access denied>
        Kernel driver in use: xhci_hcd
        Kernel modules: xhci-hcd

-- 
Configure bugmail: https://bugzilla.kernel.org/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are the assignee for the bug.