Sierra Wireless CIS [Was: Re: Epia MII 10000, 2.6.13-mm2, cs: pcmcia_socket0: unable to apply power]

[Dominik Brodowski]

Hi,

On Fri, Oct 21, 2005 at 03:54:50PM +0200, Sander wrote:
> Sorry for the delay. I became father and had to adjust priorities.

Congratulations :-)

Sorry for the delay in my reply, I don't have as good reasons, just
university examinations getting closer...

> > The CIS in /sys/class/pcmcia_socket/pcmcia_socket0/cis looks to be
> > useable, even though the two additional bytes confuse me. But decoding
> > it (using dump_cis -f from pcmciautils, run "make debugtools" to
> > compile it) shows no difference.
> > 
> > So, I'm quite curious why serial_cs doesn't attach. Could you check
> > (by adding debug printk()s [if you're not confident in how to do this,
> > I'll send you a patch]) whether serial_cs.c::attach() gets called?
> 
> Is it called 'serial_attach' in 2.6.14-rc4-mm1? That is the only
> matching function I could find.

Yes, it is.

> I'll try to insert some printk()s but I don't exactly eat source code
> for breakfast :-)

It isn't that healthy for breakfast anyway ;-)

	Dominik