pci-to-pcmcia connection with "AirPrime 5220 EVDO"

[Khamar, Kalpit K (Kalpit)]

Hi Dave and All,
I changed the PC and load the machine with Linux kernel 2.4.20-8 and install P111 card adapter but still i am not able to use any PCMCIA card from that adapter. Below is the snap shot for lspci -v

00:01.0 PCI bridge: Intel Corp.: Unknown device 2571 (rev 02) (prog-if 00 [Normal decode])
        Flags: bus master, 66Mhz, fast devsel, latency 32
        Bus: primary=00, secondary=01, subordinate=01, sec-latency=32
        Memory behind bridge: fc900000-fe9fffff
        Prefetchable memory behind bridge: e4800000-f47fffff

00:1e.0 PCI bridge: Intel Corp. 82801BA/CA/DB PCI Bridge (rev c2) (prog-if 00 [Normal decode])
        Flags: bus master, fast devsel, latency 0
        Bus: primary=00, secondary=02, subordinate=02, sec-latency=32
        I/O behind bridge: 0000c000-0000cfff
        Memory behind bridge: fea00000-feafffff

02:02.0 CardBus bridge: ENE Technology Inc CB1410 Cardbus Controller (rev 01)
        Subsystem: ENE Technology Inc CB1410 Cardbus Controller
        Flags: bus master, medium devsel, latency 168, IRQ 17
        Memory at 20001000 (32-bit, non-prefetchable) [size=4K]
        Bus: primary=02, secondary=03, subordinate=06, sec-latency=176
        Memory window 0: 20400000-207ff000 (prefetchable)
        Memory window 1: 20800000-20bff000
        I/O window 0: 00004000-000040ff
        I/O window 1: 00004400-000044ff
        16-bit legacy interface ports at 0001

And according to previous instruction i did edit /etc/pcmcia/config.opts file and below is the information which i put.

 
include port 0x100-0x4ff, port 0xc00-0xcff
include memory 0xc0000-0xfffff
include memory 0xa0000000-0xa0ffffff, memory 0x60000000-0x60ffffff

include memory 0xfea00000-0xfeafffff
include memory 0x0000c000-0x0000cfff

include memory 0xfc900000-0xfe9fffff
include memory 0xfea00000-0xfeafffff
include memory 0x20400000-0x207ff000
include memory 0x20800000-0x20bff000
include memory 0xf8000000
include memory 0x20000000
include memory 0xfd000000
include memory 0xe8000000
include memory 0xfeaff000
include memory 0x20001000
include memory 0xfeafe000

include port 0xffa0
include port 0xdc00
include port 0xc800
include port 0x0001
include port 0xe000
include port 0xe400
include port 0xe800
include port 0xec00

Still P11 adapter is not recognizing any PCMCIA cards.

I tried this on kernel 2.6.9-1.667 too but same result.

Please let me know if you need more information.
Thanks
Kalpit

-----Original Message-----
From: David Hinds [mailto:dhinds at sonic.net]
Sent: Sunday, November 21, 2004 1:34 AM
To: Khamar, Kalpit K (Kalpit)
Cc: 'linux-pcmcia at lists.infradead.org'
Subject: Re: pci-to-pcmcia connection with "AirPrime 5220 EVDO"


On Sat, Nov 20, 2004 at 09:54:13PM -0500, Khamar, Kalpit K (Kalpit) wrote:
> Hi Dave,
> I tried both the kernel (2.4.20 and 2.6.1) and both the time i got
> the same thing for IO. The result i showed you in my previous email
> was from 2.6.1 

2.6.1 is certainly a waste of time.  You should at least try 2.6.9 or
2.6.10-rc2.

> I have 12 PCI slots on my system, does it matter for this IO issue?
> Please let me know otherwise i will try another PCI-to-PCMCIA card ( P222 )

It is a BIOS and kernel issue.  You'll have the same behavior for any
CardBus bridge card.

-- Dave