Linux-2.6.7 + TI PCI1130 + Xircom CB Ethernet 10/100 = IRQ 0

[David Hinds]

On Fri, Jul 23, 2004 at 08:20:07AM +0400, DIG wrote:
> 
> ACPI: Unable to locate RSDP
...
> PCI: No IRQ known for interrupt pin A of device 0000:00:13.0.

The kernel couldn't figure out the interrupt routing for your bridge.
It also wasn't able to detect ACPI support for this laptop.  No
surprise there, since this laptop is pretty old.  There might be no
PCI interrupt wired up.  If that is the case, then the kernel PCMCIA
subsystem is not going to work for you; for CardBus support, a PCI
interrupt is required.  You could go back to the standalone drivers
with the 2.4 kernel.

-- Dave