Problem with yenta_socket (unable to map card memory) - PROGRESS

[Jeff Morrow]

David Hinds wrote:

 > On Sat, Jul 10, 2004 at 11:37:23AM -0700, Jeff Morrow wrote:
 >
 >>When I start up with the Linksys card, I get high beep, low beep, and
 >>the following messages:
 >>
 >>cs: IO port probe 0x0100-0x04ff: excluding 0x290-0x297 0x4d0-0x4d7
 >>cs: IO port probe 0x0800-0x08ff: clean.
 >>cs: IO port probe 0x0c00-0x0cff: clean.
 >>cs: IO port probe 0x0a00-0x0aff: clean.
 >>cs: IO port probe 0xa000-0xbfff: clean.
 >>cs: memory probe 0xe4000000-0xe4ffffff: excluding 0xe4000000-0xe40fffff
 >
 >
 > Oh... are these really *all* the messages you get?  Check your system
 > log as well, because if you got a low beep, then there is an error
 > message from cardmgr.

Those were all I saw at the time.  Just tried it again.  Did 
/etc/init.d/pcmcia restart and it was normal (said "watching 1 socket", 
etc).

Then I put in the card and got one high beep but no lights.  Checked 
dmesg and saw this:

Linux Kernel Card Services
   options:  [pci] [cardbus] [pm]
Yenta: CardBus bridge found at 0000:01:0a.0 [0000:0000]
Yenta: ISA IRQ mask 0x0000, PCI irq 10
Socket status: 30000086
cs: IO port probe 0x0100-0x04ff: excluding 0x290-0x297 0x4d0-0x4d7
cs: IO port probe 0x0800-0x08ff: clean.
cs: IO port probe 0x0c00-0x0cff: clean.
cs: IO port probe 0x0a00-0x0aff: clean.
cs: IO port probe 0xa000-0xbfff: clean.
cs: pcmcia_socket0: voltage interrogation timed out.

Then I typed "cardctl insert" at a command line and dmesg added this:

cs: memory probe 0xe4000000-0xe4ffffff: excluding 0xe4000000-0xe40fffff

Jeff