[PATCH] yenta: irq-routing for TI bridges

[Daniel Ritz]

[removing akpm from cc as it is pcmcia centric]

On Tuesday 24 February 2004 13:40, Russell King wrote:
> On Tue, Feb 24, 2004 at 12:59:50PM +0100, Daniel Ritz wrote:
> > there's another bug btw. one that is probably never hit and harmless too:
> > rmk's notbook has parellel isa interrupts, INTA is _not_ routed.
>
> Not true.  It has parallel ISA interrupts _and_ parallel PCI interrupts.
> It's a TI 1250.  Unfortunately, the 1250 data sheet isn't available,
> however there seems to be some consistency in the device codes to
> features offered.

ok, i see the 1250, 1450 are different. the 1410/1520 doc says nothing about it.
did i miss something about the 1410/1520/etc ?

>
> The 1450 and 1251A (both of which seem similar to 1250) has separate pins
> for PCI parallel interrupts which are outside the control of the "IRQMUX"
> register.  When these pins are not used for parallel PCI interrupts,
> they function as "GPIO3" and "IRQSER" (for PCI serial interrupts)
> respectively.  The function of these pins is controlled by the device
> control register.
>
> Please note that "IRQMUX" is a misleading definition of the register in
> question.  The register programs various multifunction pins on the device
> which _may_ be IRQ outputs, LED outputs, ZV switching outputs, audio, or
> even GPIO.

TI calls it Multifunction Routing Register for a reason :)

so i think the safe way would be:
- move routing code to 12xx_override()
- first test interrupts, do nothing if working correct
- try to reflect the settings in device control register, test again
- fall back to pci if nothing works
- handle the 125x/1450 by not touching MFUNC0
- don't do INTB routing, set INTRTIE instead (on 2 slot chips)
(- remove the bad code from 2.4 and do the same)