2.6.x kernels & PCI-to-PCMCIA bridges [again]

[komujun at nifty.com]

Dear all

Compaq WL200 works properly with my PD6729 driver under Linux 2.6.5.
This Compaq product uses the PD6729 chipset.

To load the pd6729 driver, use the modprobe command.
For example,
 modprobe pd6729
 modprobe ds
 cardmgr

Following is the output of dmesg.

Sorry for late response.

Komuro

>Linux Kernel Card Services
>  options:  [pci] [cardbus] [pm]
>PCI: Enabling device 0000:00:09.0 (0080 -> 0081)
>PCI: Found IRQ 10 for device 0000:00:09.0
>PCI: Sharing IRQ 10 with 0000:00:04.2
>pd6729: Cirrus PD6729 PCI to PCMCIA Bridge at 0xd000 on irq 10 
>pd6729: configured as a 2 socket device.
>pd6729: Enabling PCI_COMMAND_MEMORY.
>cs: IO port probe 0x0c00-0x0cff: clean.
>cs: IO port probe 0x0100-0x04ff: excluding 0x170-0x177 0x370-0x37f 0x3c0->0x3
e7 0x4d0-0x4d7
>cs: IO port probe 0x0a00-0x0aff: clean.
>cs: memory probe 0xa0000000-0xa0ffffff: clean.
>orinoco_cs.c 0.13e (David Gibson <hermes at gibson.dropbear.id.au> and others)
>eth0: Station identity 001f:0002:0000:0006
>eth0: Looks like an Intersil firmware version 0.6.2
>eth0: Intersil firmware earlier than v0.8.x - several features not supported
>eth0: Ad-hoc demo mode supported
>eth0: MAC address 00:50:8B:xx:xx:xx
>eth0: Station name "Prism  I"
>eth0: ready
>eth0: index 0x01: Vcc 3.3, irq 10, io 0x0100-0x013f