Hi

I bought a sunix pci parallel port to communicated with some custom electronics I hope to build using fc8 and parapin. The port works but it is mapped to 0x8000 and is recognized as an spp. Is there a way to map to say 0x278 and ecp? I've tried kernel options with no success. The bios uses irq 5, but the card requests irq 21. Is this a problem?

thanks

Ben


ACPI: PCI Interrupt Link [APC4] enabled at IRQ 19
ACPI: PCI Interrupt 0000:01:07.0[A] -> Link [APC4] -> GSI 19 (level, low) -> IRQ 21
PCI parallel port detected: 1409:7268, I/O at 0x8000(0x8400)
parport1: PC-style at 0x8000 (0x8400) [PCSPP,TRISTATE]



01:07.0 Parallel controller: Timedia Technology Co Ltd Unknown device 7268 (rev 01) (prog-if 02 [ECP])
        Subsystem: Timedia Technology Co Ltd Unknown device 0103
        Flags: stepping, medium devsel, IRQ 21
        I/O ports at 8000 [size=8]
        I/O ports at 8400 [size=8]