43210 My U-Boot v0.1+e۳6ೊY966z8r ]v}t鏧\I;6rHܼ´` 88O]{ØeZdtŸ[NW6`9xyv*,U뫆*QE>p ٮ`Ε ~4 U-Boot 1.1.1 (Jan 5 2006 - 22:27:51) U-Boot code: 81EC0000 -> 81EF7578 BSS: -> 81EF8C94 SDRAM : 64M detected Detecting chip revision... Suzi R2B bootstrap SW version 4 RAM Configuration: Bank #0: 80000000 60 MB Bank #1: 00000000 0 kB Flash: 0 kB NAND: ** **Sandisk MLC controller on pnx4008, PIO mode, software ECC **PK:selected the device NAND device: Manufacturer ID: 0xec, Chip ID: 0xa1 (Samsung NAND 128MiB 1,8V 8-bi t) this->options=3221487645d if (mtd->oobblock > 512) Scanning device for bad blocks check_short_pattern: p[td->offs + i]: 84 td->pattern[i]:ff Bad eraseblock 96 at 0x00c00000 check_short_pattern: p[td->offs + i]: 2c td->pattern[i]:ff Bad eraseblock 97 at 0x00c20000 RN: NAND flash probing at 0x20020000 Finished In: console Out: console Err: console Hit any key to stop autoboot: 2  1  0 Loading from device 0: NAND 128MiB 1,8V 8-bit at 0x200b8000 (offset 0xd00000) Dec 20: nand_isbad_bbt: this->bbt_erase_shift=17 block=208 Dec 20: nand_isbad_bbt: res=0 cmd & NANDRW_READ: 1 Jan 5: do_nandboot(): ecc_status=0 Jan 5: do_nandboot(): ecc_status=-1 nand_read_ecc: Failed ECC read, page 0x00001a00 Jan 5: do_nandboot(): ecc_status=0 Jan 5: do_nandboot(): ecc_status=0 Jan 5: do_nandboot(): ecc_status=0 Jan 5: do_nandboot(): ecc_status=-1 nand_read_ecc: Failed ECC read, page 0x00001a00 Jan 5: do_nandboot(): ecc_status=0 Jan 5: do_nandboot(): ecc_status=0 if (ret)** Read error on 0 Boot reached stage -1 Reodor #