Hi Andrew

>I now have the DoC detecting and mountable, but it is mounting read-only 
>and I can't seem ot make it mount read-write.  Any ideas?
>
>Also, I think the geometry, or pseudo-geometry or whatever of the chip is 
>out of whack.  This is what fdisk is telling me:
>
>Disk /dev/nftla: 1 heads, 64064 sectors, 1 cylinders
>Units = cylinders of 64064 * 512 bytes
>
>      Device Boot    Start       End    Blocks   Id  System
>/dev/nftla1             1         1     32031+  83  Linux
>Partition 1 has different physical/logical endings:
>      phys=(256, 0, 0) logical=(0, 0, 64064)
>Partition 1 does not end on cylinder boundary:
>      phys=(256, 0, 0) should be (256, 0, 64064)

I am not able to help you here, but I can tell you, that I was able
to mount the DOC 2000 (48M) as read-write with simple mount command.
And I had the similar output from the fdisk as you have. 
(Now I have problems with LILO)

I don't know what is going here, because both the Start
and the End are set to 1 ???

Is /dev/nftla1 mounted during the boot (e.g. in /etc/fstab)?

Regards,
Mateo

_____________________________________________________________
Brezplacen E-mail - http://email.star.si
Brezplacen prostor 100 MB,lastna domena - http://www.slohosting.com

_____________________________________________________________
Promote your group and strengthen ties to your members with email@yourgroup.org by Everyone.net  http://www.everyone.net/?btn=tag