[PATCH] mtd: spinand: Disable continuous read during probe

[David LaPorte]

Macronix serial NAND devices with continuous read support do not
clear the configuration register on soft reset and lack a hardware
reset pin. When continuous read is interrupted (e.g., during reboot),
the feature remains enabled at the device level.

With continuous read enabled, the OOB area becomes inaccessible and
all reads are instead directed to the main area. As a result, during
partition allocation as part of MTD device registration, the first two
bytes of the main area for the master block are read and indicate that
the block is bad. This process repeats for every subsequent block for
the partition.

All reads and writes that reference the BBT find no good blocks and
fail.

The only paths for recovery from this state are triggering the
continuous read feature by way of raw MTD reads or through a NAND
device power drain.

Disable continuous read explicitly during spinand probe to ensure
quiescent feature state.

Fixes: 631cfdd0520d ("mtd: spi-nand: Add continuous read support")
Signed-off-by: David LaPorte <dalaport at amazon.com>
Reviewed-by: Gunnar Kudrjavets <gunnarku at amazon.com>
---
Testing details:
- Instrumented feature enablement and verified fix with affected Macronix
  serial NAND device:  warm reboot without patch marks all blocks bad
  during partition allocation; with patch applied, device registers
  cleanly with no bad blocks marked
- Patch cherry-picks cleanly to mainline v6.19-rc6 and builds without
  warnings
- Boot tested mainline + patch on aarch64 host without SPI interface
---
 drivers/mtd/nand/spi/core.c | 1 +
 1 file changed, 1 insertion(+)

diff --git a/drivers/mtd/nand/spi/core.c b/drivers/mtd/nand/spi/core.c
index d207286572d8..1fb05ac8678b 100644
--- a/drivers/mtd/nand/spi/core.c
+++ b/drivers/mtd/nand/spi/core.c
@@ -859,6 +859,7 @@ static void spinand_cont_read_init(struct spinand_device *spinand)
 	    (engine_type == NAND_ECC_ENGINE_TYPE_ON_DIE ||
 	     engine_type == NAND_ECC_ENGINE_TYPE_NONE)) {
 		spinand->cont_read_possible = true;
+		spinand_cont_read_enable(spinand, false);
 	}
 }

--
2.43.0