[PATCH 05/24] spi: cadence-qspi: Support per spi-mem operation frequency switches

[Miquel Raynal]

Every ->exec_op() call correctly configures the spi bus speed to the
maximum allowed frequency for the memory using the constant spi default
parameter. Since we can now have per-operation constraints, let's use
the value that comes from the spi-mem operation structure instead. In
case there is no specific limitation for this operation, the default spi
device value will be given anyway.

The per-operation frequency capability is thus advertised to the spi-mem
core.

Signed-off-by: Miquel Raynal <miquel.raynal at bootlin.com>
---
 drivers/spi/spi-cadence-quadspi.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/spi/spi-cadence-quadspi.c b/drivers/spi/spi-cadence-quadspi.c
index 05ebb03d319f..d285c7698291 100644
--- a/drivers/spi/spi-cadence-quadspi.c
+++ b/drivers/spi/spi-cadence-quadspi.c
@@ -1407,7 +1407,7 @@ static int cqspi_mem_process(struct spi_mem *mem, const struct spi_mem_op *op)
 	struct cqspi_flash_pdata *f_pdata;
 
 	f_pdata = &cqspi->f_pdata[spi_get_chipselect(mem->spi, 0)];
-	cqspi_configure(f_pdata, mem->spi->max_speed_hz);
+	cqspi_configure(f_pdata, op->max_freq);
 
 	if (op->data.dir == SPI_MEM_DATA_IN && op->data.buf.in) {
 	/*
@@ -1655,6 +1655,7 @@ static const struct spi_controller_mem_ops cqspi_mem_ops = {
 
 static const struct spi_controller_mem_caps cqspi_mem_caps = {
 	.dtr = true,
+	.per_op_freq = true,
 };
 
 static int cqspi_setup_flash(struct cqspi_st *cqspi)
-- 
2.43.0