[PATCH v10 1/6] mtd: spi-nor: add Octal DTR support for Macronix flash

[Tudor Ambarus]

On 10/4/24 10:05 AM, Alvin Zhou wrote:
>>> +     /* Read flash ID to make sure the switch was successful. */
>>> +     ret = spi_nor_read_id(nor, 4, 4, buf, SNOR_PROTO_8_8_8_DTR);
>> can we use nor->addr_nbytes for the second argument? Please test and
>> confirm. No need to resend for this, just confirm and I can amend when
>> applying.
> The following is the process of spi_nor_scan()
> int spi_nor_scan(...)
> {
> ......
> ret = spi_nor_init_params(nor);
> ......
> ret = spi_nor_setup(nor, hwcaps);
> ......
> }
> First, within the spi_nor_parse_sfdp() function inside
> spi_nor_init_params(): nor->params->addr_nbytes is set based on the
> SFDP, while nor->addr_nbytes is not available. Therefore, the second
> argument cannot use nor->addr_nbytes but can use
> nor->params->addr_nbytes. Additionally, For Macronix Octal NOR Flash


nor->addr_nbytes is set in spi_nor_setup().
spi_nor_set_octal_dtr() is called after spi_nor_setup(), thus you can
use nor->addr_nbytes.

> in Octal DDR mode, both the address and dummy cycles are fixed at 4
> in READID, so setting the second and third argument to 4 is also valid.

but we don't want magic numbers or states that are not tracked, so use
the parameters set

> Moreover, nor->addr_nbytes is set within the spi_nor_setup() function.

yep, use it then.