[PATCH] memory: fsl_ifc: Make FSL_IFC config visible and selectable

[Esben Haabendal]

Krzysztof Kozlowski <krzk at kernel.org> writes:

> On 27/05/2024 09:47, Esben Haabendal wrote:
>> 
>> Ok, I seem to still be confused as to what you want from me. If you are
>> saying that the kernel is not supposed to care about out-of-tree DTS
>> (and thereby any bootloader provided DTB), I would like to bring your
>> attention to arch/arm/boot/dts/nxp/ls/ls1021a-twr.dts in upstream:
>> 
>> &ifc {
>>         #address-cells = <2>;
>>         #size-cells = <1>;
>>         /* NOR Flash on board */
>>         ranges = <0x0 0x0 0x0 0x60000000 0x08000000>;
>>         status = "okay";
>> 
>>         nor at 0,0 {
>>                 #address-cells = <1>;
>>                 #size-cells = <1>;
>>                 compatible = "cfi-flash";
>>                 reg = <0x0 0x0 0x8000000>;
>>                 big-endian;
>>                 bank-width = <2>;
>>                 device-width = <1>;
>>         };
>> };
>> 
>
> I don't understand why it took so many emails to answer that (my first)
> question...

Because I did not understand the question. Primarely because I was (and
is) surprised that out-of-tree DTS is not supported. I was convinced
that out-of-tree DTS was the right way for hardware which is not
commonly available.

> Sounds good, however you did not update the existing select.
> Drivers are not supposed to select user-visible symbols (leads to
> issues), so you need to change it to depends and update defconfigs.

Do you wan this split into multiple commits, or a single commit changing
the Kconfig to make FSL_IFC user-visible, and changing select of it to
DEPENDS, and updating the related defconfig(s)?

/Esben