[PATCH 11/11] MIPS: mobileye: eyeq5: add octal flash node to eval board DTS

[Tudor Ambarus]

On 3/8/24 17:18, Théo Lebrun wrote:
> Add SPI-NOR octal flash node to evaluation board devicetree.
> 
> Signed-off-by: Théo Lebrun <theo.lebrun at bootlin.com>
> ---
>  arch/mips/boot/dts/mobileye/eyeq5-epm5.dts | 15 +++++++++++++++
>  1 file changed, 15 insertions(+)
> 
> diff --git a/arch/mips/boot/dts/mobileye/eyeq5-epm5.dts b/arch/mips/boot/dts/mobileye/eyeq5-epm5.dts
> index 6898b2d8267d..0e5fee7b680c 100644
> --- a/arch/mips/boot/dts/mobileye/eyeq5-epm5.dts
> +++ b/arch/mips/boot/dts/mobileye/eyeq5-epm5.dts
> @@ -21,3 +21,18 @@ memory at 0 {
>  		      <0x8 0x02000000 0x0 0x7E000000>;
>  	};
>  };
> +
> +&ospi {
> +	flash0: flash at 0 {
> +		compatible = "jedec,spi-nor";
> +		reg = <0>; /* chip select */
> +
> +		spi-max-frequency = <40000000>;
> +		spi-rx-bus-width = <8>;
> +		cdns,read-delay = <1>;
> +		cdns,tshsl-ns = <400>;
> +		cdns,tsd2d-ns = <400>;
> +		cdns,tchsh-ns = <125>;
> +		cdns,tslch-ns = <50>;

These cdns properties look bad, they bypass SPI NOR entirely. I'd check
if these timings can be determined at SFDP parsing time, then I'd pass
them to the SPI controller.

I see these properties are already accepted in the bindings file for few
years now. Something to improve later on.