[PATCH 02/26] sd: move zone limits setup out of sd_read_block_characteristics

Damien Le Moal dlemoal at kernel.org
Tue Jun 11 00:25:18 PDT 2024


On 6/11/24 2:54 PM, Christoph Hellwig wrote:
> On Tue, Jun 11, 2024 at 07:52:39AM +0200, Christoph Hellwig wrote:
>>> Maybe we should clear the other zone related limits here ? If the drive is
>>> reformatted/converted from SMR to CMR (FORMAT WITH PRESET), the other zone
>>> limits may be set already, no ?
>>
>> blk_validate_zoned_limits already takes care of that.
> 
> Sorry, brainfart.  The integrity code does that, but not the zoned
> code.  I suspect the core code might be a better place for it,
> though.

Yes. Just replied to your previous email before seeing this one.
I think that:

static int blk_validate_zoned_limits(struct queue_limits *lim)
{
        if (!lim->zoned) {
                if (WARN_ON_ONCE(lim->max_open_zones) ||
                    WARN_ON_ONCE(lim->max_active_zones) ||
                    WARN_ON_ONCE(lim->zone_write_granularity) ||
                    WARN_ON_ONCE(lim->max_zone_append_sectors))
                        return -EINVAL;
                return 0;
        }
	...

could be changed into:

static int blk_validate_zoned_limits(struct queue_limits *lim)
{
	if (!lim->zoned) {
                lim->max_open_zones = 0;
		lim->max_active_zones = 0;
		lim->zone_write_granularity = 0;
		lim->max_zone_append_sectors = 0
		return 0;
	}

But then we would not see "bad" drivers. Could have a small

blk_clear_zoned_limits(struct queue_limits *lim)

helper too.

-- 
Damien Le Moal
Western Digital Research




More information about the linux-mtd mailing list