[PATCH 0/5] Add QPIC SPI NAND driver

[Md Sadre Alam]

On 2/21/2024 4:31 PM, Krzysztof Kozlowski wrote:
> On 21/02/2024 11:34, Md Sadre Alam wrote:
>>
>>
>> On 2/20/2024 5:06 PM, Krzysztof Kozlowski wrote:
>>> On 20/02/2024 12:32, Md Sadre Alam wrote:
>>>>
>>>>
>>>> On 2/19/2024 6:34 PM, Manivannan Sadhasivam wrote:
>>>>> On Thu, Feb 15, 2024 at 07:18:51PM +0530, Md Sadre Alam wrote:
>>>>>> This series of patches will add initial supports
>>>>>> for QPIC SPI NAND driver.
>>>>>>
>>>>>> Currently this driver support following commands
>>>>>>
>>>>>> -- RESET
>>>>>> -- READ ID
>>>>>> -- BLOCK ERASE
>>>>>> -- PAGE READ
>>>>>> -- PAGE WRITE
>>>>>> -- GET FEATURE
>>>>>> -- SET FEATURE
>>>>>> -- BAD BLOCK CHECK
>>>>>>
>>>>>> This driver has been tested with dd command with read/write page
>>>>>> with multiple file size 1MiB, 10MiB,40MiB etc.
>>>>>> Also tested with "mtd" command like mtd erase, mtd write, mtd verify etc.
>>>>>>
>>>>>
>>>>> This is not the first version isn't it? Where is the changelog describing what
>>>>> has changed since then?
>>>>
>>>>      The earlier patch was the RFC for design review only.
>>>
>>> RFC is state of patch, not version. This is v2 then.
>>>
>>> These RFC postings are really becoming mess. Some people make multiple
>>> RFCs and then post v1 hiding entire previous history... And why even
>>> bother with calling it RFC?
>>
>>    Sorry, I was not aware of this. Shall I post the next one as V3
>>    and add references to the RFC patch and this patch in the cover
>>    letter of V3?
> 
> Yes, like with every posting.
Thank you.
> 
> Best regards,
> Krzysztof
>