[PATCH] mtd: rawnand: davinci: make platform_data private
Bartosz Golaszewski
brgl at bgdev.pl
Wed Aug 14 05:21:18 PDT 2024
From: Bartosz Golaszewski <bartosz.golaszewski at linaro.org>
There are no longer any users of the platform data for davinci rawnand
in board files. We can remove the public pdata headers and move the
structures that are still used into the driver compilation unit while
removing the rest.
Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski at linaro.org>
---
drivers/mtd/nand/raw/davinci_nand.c | 70 +++++++++++++--
.../linux/platform_data/mtd-davinci-aemif.h | 36 --------
include/linux/platform_data/mtd-davinci.h | 88 -------------------
3 files changed, 65 insertions(+), 129 deletions(-)
delete mode 100644 include/linux/platform_data/mtd-davinci-aemif.h
delete mode 100644 include/linux/platform_data/mtd-davinci.h
diff --git a/drivers/mtd/nand/raw/davinci_nand.c b/drivers/mtd/nand/raw/davinci_nand.c
index 051deea768db..392678143a36 100644
--- a/drivers/mtd/nand/raw/davinci_nand.c
+++ b/drivers/mtd/nand/raw/davinci_nand.c
@@ -20,8 +20,71 @@
#include <linux/slab.h>
#include <linux/of.h>
-#include <linux/platform_data/mtd-davinci.h>
-#include <linux/platform_data/mtd-davinci-aemif.h>
+#define NRCSR_OFFSET 0x00
+#define NANDFCR_OFFSET 0x60
+#define NANDFSR_OFFSET 0x64
+#define NANDF1ECC_OFFSET 0x70
+
+/* 4-bit ECC syndrome registers */
+#define NAND_4BIT_ECC_LOAD_OFFSET 0xbc
+#define NAND_4BIT_ECC1_OFFSET 0xc0
+#define NAND_4BIT_ECC2_OFFSET 0xc4
+#define NAND_4BIT_ECC3_OFFSET 0xc8
+#define NAND_4BIT_ECC4_OFFSET 0xcc
+#define NAND_ERR_ADD1_OFFSET 0xd0
+#define NAND_ERR_ADD2_OFFSET 0xd4
+#define NAND_ERR_ERRVAL1_OFFSET 0xd8
+#define NAND_ERR_ERRVAL2_OFFSET 0xdc
+
+/* NOTE: boards don't need to use these address bits
+ * for ALE/CLE unless they support booting from NAND.
+ * They're used unless platform data overrides them.
+ */
+#define MASK_ALE 0x08
+#define MASK_CLE 0x10
+
+struct davinci_nand_pdata {
+ uint32_t mask_ale;
+ uint32_t mask_cle;
+
+ /*
+ * 0-indexed chip-select number of the asynchronous
+ * interface to which the NAND device has been connected.
+ *
+ * So, if you have NAND connected to CS3 of DA850, you
+ * will pass '1' here. Since the asynchronous interface
+ * on DA850 starts from CS2.
+ */
+ uint32_t core_chipsel;
+
+ /* for packages using two chipselects */
+ uint32_t mask_chipsel;
+
+ /* board's default static partition info */
+ struct mtd_partition *parts;
+ unsigned int nr_parts;
+
+ /* none == NAND_ECC_ENGINE_TYPE_NONE (strongly *not* advised!!)
+ * soft == NAND_ECC_ENGINE_TYPE_SOFT
+ * else == NAND_ECC_ENGINE_TYPE_ON_HOST, according to ecc_bits
+ *
+ * All DaVinci-family chips support 1-bit hardware ECC.
+ * Newer ones also support 4-bit ECC, but are awkward
+ * using it with large page chips.
+ */
+ enum nand_ecc_engine_type engine_type;
+ enum nand_ecc_placement ecc_placement;
+ u8 ecc_bits;
+
+ /* e.g. NAND_BUSWIDTH_16 */
+ unsigned int options;
+ /* e.g. NAND_BBT_USE_FLASH */
+ unsigned int bbt_options;
+
+ /* Main and mirror bbt descriptor overrides */
+ struct nand_bbt_descr *bbt_td;
+ struct nand_bbt_descr *bbt_md;
+};
/*
* This is a device driver for the NAND flash controller found on the
@@ -54,8 +117,6 @@ struct davinci_nand_info {
uint32_t mask_cle;
uint32_t core_chipsel;
-
- struct davinci_aemif_timing *timing;
};
static DEFINE_SPINLOCK(davinci_nand_lock);
@@ -775,7 +836,6 @@ static int nand_davinci_probe(struct platform_device *pdev)
info->chip.options = pdata->options;
info->chip.bbt_td = pdata->bbt_td;
info->chip.bbt_md = pdata->bbt_md;
- info->timing = pdata->timing;
info->current_cs = info->vaddr;
info->core_chipsel = pdata->core_chipsel;
diff --git a/include/linux/platform_data/mtd-davinci-aemif.h b/include/linux/platform_data/mtd-davinci-aemif.h
deleted file mode 100644
index a49826214a39..000000000000
--- a/include/linux/platform_data/mtd-davinci-aemif.h
+++ /dev/null
@@ -1,36 +0,0 @@
-/*
- * TI DaVinci AEMIF support
- *
- * Copyright 2010 (C) Texas Instruments, Inc. https://www.ti.com/
- *
- * This file is licensed under the terms of the GNU General Public License
- * version 2. This program is licensed "as is" without any warranty of any
- * kind, whether express or implied.
- */
-#ifndef _MACH_DAVINCI_AEMIF_H
-#define _MACH_DAVINCI_AEMIF_H
-
-#include <linux/platform_device.h>
-
-#define NRCSR_OFFSET 0x00
-#define AWCCR_OFFSET 0x04
-#define A1CR_OFFSET 0x10
-
-#define ACR_ASIZE_MASK 0x3
-#define ACR_EW_MASK BIT(30)
-#define ACR_SS_MASK BIT(31)
-
-/* All timings in nanoseconds */
-struct davinci_aemif_timing {
- u8 wsetup;
- u8 wstrobe;
- u8 whold;
-
- u8 rsetup;
- u8 rstrobe;
- u8 rhold;
-
- u8 ta;
-};
-
-#endif
diff --git a/include/linux/platform_data/mtd-davinci.h b/include/linux/platform_data/mtd-davinci.h
deleted file mode 100644
index dd474dd44848..000000000000
--- a/include/linux/platform_data/mtd-davinci.h
+++ /dev/null
@@ -1,88 +0,0 @@
-/* SPDX-License-Identifier: GPL-2.0-or-later */
-/*
- * mach-davinci/nand.h
- *
- * Copyright © 2006 Texas Instruments.
- *
- * Ported to 2.6.23 Copyright © 2008 by
- * Sander Huijsen <Shuijsen at optelecom-nkf.com>
- * Troy Kisky <troy.kisky at boundarydevices.com>
- * Dirk Behme <Dirk.Behme at gmail.com>
- *
- * --------------------------------------------------------------------------
- */
-
-#ifndef __ARCH_ARM_DAVINCI_NAND_H
-#define __ARCH_ARM_DAVINCI_NAND_H
-
-#include <linux/mtd/rawnand.h>
-
-#define NANDFCR_OFFSET 0x60
-#define NANDFSR_OFFSET 0x64
-#define NANDF1ECC_OFFSET 0x70
-
-/* 4-bit ECC syndrome registers */
-#define NAND_4BIT_ECC_LOAD_OFFSET 0xbc
-#define NAND_4BIT_ECC1_OFFSET 0xc0
-#define NAND_4BIT_ECC2_OFFSET 0xc4
-#define NAND_4BIT_ECC3_OFFSET 0xc8
-#define NAND_4BIT_ECC4_OFFSET 0xcc
-#define NAND_ERR_ADD1_OFFSET 0xd0
-#define NAND_ERR_ADD2_OFFSET 0xd4
-#define NAND_ERR_ERRVAL1_OFFSET 0xd8
-#define NAND_ERR_ERRVAL2_OFFSET 0xdc
-
-/* NOTE: boards don't need to use these address bits
- * for ALE/CLE unless they support booting from NAND.
- * They're used unless platform data overrides them.
- */
-#define MASK_ALE 0x08
-#define MASK_CLE 0x10
-
-struct davinci_nand_pdata { /* platform_data */
- uint32_t mask_ale;
- uint32_t mask_cle;
-
- /*
- * 0-indexed chip-select number of the asynchronous
- * interface to which the NAND device has been connected.
- *
- * So, if you have NAND connected to CS3 of DA850, you
- * will pass '1' here. Since the asynchronous interface
- * on DA850 starts from CS2.
- */
- uint32_t core_chipsel;
-
- /* for packages using two chipselects */
- uint32_t mask_chipsel;
-
- /* board's default static partition info */
- struct mtd_partition *parts;
- unsigned nr_parts;
-
- /* none == NAND_ECC_ENGINE_TYPE_NONE (strongly *not* advised!!)
- * soft == NAND_ECC_ENGINE_TYPE_SOFT
- * else == NAND_ECC_ENGINE_TYPE_ON_HOST, according to ecc_bits
- *
- * All DaVinci-family chips support 1-bit hardware ECC.
- * Newer ones also support 4-bit ECC, but are awkward
- * using it with large page chips.
- */
- enum nand_ecc_engine_type engine_type;
- enum nand_ecc_placement ecc_placement;
- u8 ecc_bits;
-
- /* e.g. NAND_BUSWIDTH_16 */
- unsigned options;
- /* e.g. NAND_BBT_USE_FLASH */
- unsigned bbt_options;
-
- /* Main and mirror bbt descriptor overrides */
- struct nand_bbt_descr *bbt_td;
- struct nand_bbt_descr *bbt_md;
-
- /* Access timings */
- struct davinci_aemif_timing *timing;
-};
-
-#endif /* __ARCH_ARM_DAVINCI_NAND_H */
--
2.43.0
More information about the linux-mtd
mailing list