[PATCH v2] mtd: spi-nor: Improve reporting for software reset failures

[AceLan Kao]

From: "Chia-Lin Kao (AceLan)" <acelan.kao at canonical.com>

When the software reset command isn't supported, we now report it as an
informational message(dev_info) instead of a warning(dev_warn). 
This adjustment helps avoid unnecessary alarm and confusion regarding
software reset capabilities.

v2. only lower the priority for the not supported failure

Signed-off-by: Chia-Lin Kao (AceLan) <acelan.kao at canonical.com>
---
 drivers/mtd/spi-nor/core.c | 10 ++++++++--
 1 file changed, 8 insertions(+), 2 deletions(-)

diff --git a/drivers/mtd/spi-nor/core.c b/drivers/mtd/spi-nor/core.c
index 1b0c6770c14e..76920dbc568b 100644
--- a/drivers/mtd/spi-nor/core.c
+++ b/drivers/mtd/spi-nor/core.c
@@ -3252,7 +3252,10 @@ static void spi_nor_soft_reset(struct spi_nor *nor)
 
 	ret = spi_mem_exec_op(nor->spimem, &op);
 	if (ret) {
-		dev_warn(nor->dev, "Software reset failed: %d\n", ret);
+		if (ret == -ENOTSUPP)
+			dev_info(nor->dev, "Software reset enable command doesn't support: %d\n", ret);
+		else
+			dev_warn(nor->dev, "Software reset failed: %d\n", ret);
 		return;
 	}
 
@@ -3262,7 +3265,10 @@ static void spi_nor_soft_reset(struct spi_nor *nor)
 
 	ret = spi_mem_exec_op(nor->spimem, &op);
 	if (ret) {
-		dev_warn(nor->dev, "Software reset failed: %d\n", ret);
+		if (ret == -ENOTSUPP)
+			dev_info(nor->dev, "Software reset command doesn't support: %d\n", ret);
+		else
+			dev_warn(nor->dev, "Software reset failed: %d\n", ret);
 		return;
 	}
 
-- 
2.34.1