[PATCH 0/2] Add SEAMA partition types

[Linus Walleij]

On Mon, May 22, 2023 at 4:46 PM Miquel Raynal <miquel.raynal at bootlin.com> wrote:

> > The mtdsplit code uses different magic numbers to identify where
> > the different partitions start.
>
> Is mtdsplit acting on a device or on a partition?

It acts on a partition, usually you use a fixed-partitition scheme to point
out the different chunks in the flash and then mtdsplit comes in to
do its job.

> Right now you define
> a partition to be compatible with seama, I would have imagined the
> partitions container should be compatible with seama instead of
> fixed-partitions, but I haven't looked at the whole implementation, so
> maybe my comment is just wrong.

The NAND flash on my device needs it to be a partition, it looks
like so:

&nandcs {
        /* Spansion S34ML01G2, 128MB with 128KB erase blocks */
        partitions {
                compatible = "fixed-partitions";
                #address-cells = <1>;
                #size-cells = <1>;

                firmware at 0 {
                        compatible = "seama";
                        label = "firmware";
                        reg = <0x00000000 0x08000000>;
                };
        };
};

The reason is mainly that other devices may put eraseblocks
aside for other things, and the SEAMA format itself does not
know its extents (it needs to be told where the end of the
partition is).

> > One such type of partition is seama, so the code needs to know
> > that it should look for seama magic to determine the size and
> > split this partition in a kernel and rootfs part. This is the code:
> > https://git.openwrt.org/?p=openwrt/openwrt.git;a=tree;f=target/linux/generic/files/drivers/mtd/mtdsplit;h=3e0df856713a84b1decf17190f171cb10ce7a757;hb=HEAD
>
> That's very informative, thanks for all the context. I believe this
> could actually be part of the binding description (not the "this is an
> openWRT stuff", of course).

Hm I'll think about what I can put in there...

Yours,
Linus Walleij