[PATCH v3 0/2] mtd: spi-nor: Avoid setting SRWD bit in SR

[Amit Kumar Mahapatra]

Setting the status register write disable (SRWD) bit in the status
register (SR) with WP# signal of the flash not connected or wrongly tied to
GND (that includes internal pull-downs), will configure the SR permanently 
as read-only. To avoid this a boolean type DT property "no-wp" is 
introduced. If this property is defined, the spi-nor doesn't set the SRWD 
bit in SR while performing flash protection operation.
---
BRANCH: for-next

Changes in v3:
- Updated DT property name to "no-wp".
- Removed Reviewed-by tag from 1/2 as the DT property name has changed.
- Updated spi-nor flag name to SNOR_F_NO_WP.
- Updated DT property description.
- Updated patch description.
- Updated comments in swp.c file.
- Replaced WP with WP# in patch descriptions, comments & DT property 
  description.

Changes in v2:
- Modified DT property description to add information about a
  valid use case.
- Added Reviewed-by tag in 1/2.
- Updated comment description in 2/2.
---
Amit Kumar Mahapatra (2):
  dt-bindings: mtd: jedec, spi-nor: Add DT property to avoid setting
    SRWD bit in status register
  mtd: spi-nor: Avoid setting SRWD bit in SR if WP# signal not connected

 .../devicetree/bindings/mtd/jedec,spi-nor.yaml    | 15 +++++++++++++++
 drivers/mtd/spi-nor/core.c                        |  3 +++
 drivers/mtd/spi-nor/core.h                        |  1 +
 drivers/mtd/spi-nor/swp.c                         |  9 +++++++--
 4 files changed, 26 insertions(+), 2 deletions(-)

-- 
2.17.1