[PATCH v4 1/5] mtd: rawnand: qcom: Implement exec_op()

[Md Sadre Alam]

Implement exec_op() so we can later get rid of the legacy interface
implementation.

Co-developed-by: Sricharan Ramabadhran <quic_srichara at quicinc.com>
Signed-off-by: Sricharan Ramabadhran <quic_srichara at quicinc.com>
Signed-off-by: Md Sadre Alam <quic_mdalam at quicinc.com>
---
Change in [v4]

* No change for this patch, since this is part of exec_op
  series posting new patch.

Change in [v3]

* Removed NAND_CMD_STATUS check in pre_command and move
  it to status exec_op.

* Removed min() , since this check not needed

* Removed all the dummy APIs of exec_ops, and added it
  into same patch where its getting added.

* Added qcom_check_op() API to check for unsupported feature
  by controller in check_only path.

Change in [v2]

* Missed to post Cover-letter, so posting v2 patch with cover-letter

Change in [v1]

* Added initial support for exec_ops.

 drivers/mtd/nand/raw/qcom_nandc.c | 159 ++++++++++++++++++++++++++++++
 1 file changed, 159 insertions(+)

diff --git a/drivers/mtd/nand/raw/qcom_nandc.c b/drivers/mtd/nand/raw/qcom_nandc.c
index 72d6168d8a1b..d9c4c9fe2fe8 100644
--- a/drivers/mtd/nand/raw/qcom_nandc.c
+++ b/drivers/mtd/nand/raw/qcom_nandc.c
@@ -157,6 +157,7 @@
 #define	OP_PAGE_PROGRAM_WITH_ECC	0x7
 #define	OP_PROGRAM_PAGE_SPARE		0x9
 #define	OP_BLOCK_ERASE			0xa
+#define	OP_CHECK_STATUS			0xc
 #define	OP_FETCH_ID			0xb
 #define	OP_RESET_DEVICE			0xd
 
@@ -235,6 +236,8 @@ nandc_set_reg(chip, reg,			\
  */
 #define NAND_ERASED_CW_SET		BIT(4)
 
+#define MAX_ADDRESS_CYCLE		5
+#define MAX_CHUNK_SIZE			SZ_8K
 /*
  * This data type corresponds to the BAM transaction which will be used for all
  * NAND transfers.
@@ -447,6 +450,29 @@ struct qcom_nand_boot_partition {
 	u32 page_size;
 };
 
+/*
+ * Qcom op for each exec_op transfer
+ *
+ * @data_instr:			data instruction pointer
+ * @data_instr_idx:		data instruction index
+ * @rdy_timeout_ms:		wait ready timeout in ms
+ * @rdy_delay_ns:		Additional delay in ns
+ * @addr1_reg:			Address1 register value
+ * @addr2_reg:			Address2 register value
+ * @cmd_reg:			CMD register value
+ * @flag:			flag for misc instruction
+ */
+struct qcom_op {
+	const struct nand_op_instr *data_instr;
+	unsigned int data_instr_idx;
+	unsigned int rdy_timeout_ms;
+	unsigned int rdy_delay_ns;
+	u32 addr1_reg;
+	u32 addr2_reg;
+	u32 cmd_reg;
+	u8 flag;
+};
+
 /*
  * NAND chip structure
  *
@@ -2867,8 +2893,141 @@ static int qcom_nand_attach_chip(struct nand_chip *chip)
 	return 0;
 }
 
+static int qcom_op_cmd_mapping(struct qcom_nand_controller *nandc, u8 cmd,
+			       struct qcom_op *q_op)
+{
+	int ret;
+
+	switch (cmd) {
+	case NAND_CMD_RESET:
+		ret = OP_RESET_DEVICE;
+		break;
+	case NAND_CMD_READID:
+		ret = OP_FETCH_ID;
+		break;
+	case NAND_CMD_PARAM:
+		if (nandc->props->qpic_v2)
+			ret = OP_PAGE_READ_ONFI_READ;
+		else
+			ret = OP_PAGE_READ;
+		break;
+	case NAND_CMD_ERASE1:
+	case NAND_CMD_ERASE2:
+		ret = OP_BLOCK_ERASE;
+		break;
+	case NAND_CMD_STATUS:
+		ret = OP_CHECK_STATUS;
+		break;
+	case NAND_CMD_PAGEPROG:
+		ret = OP_PROGRAM_PAGE;
+		break;
+	default:
+		break;
+	}
+
+	return ret;
+}
+
+/* NAND framework ->exec_op() hooks and related helpers */
+static void qcom_parse_instructions(struct nand_chip *chip,
+				    const struct nand_subop *subop,
+					struct qcom_op *q_op)
+{
+	struct qcom_nand_controller *nandc = get_qcom_nand_controller(chip);
+	const struct nand_op_instr *instr = NULL;
+	unsigned int op_id;
+	int i;
+
+	memset(q_op, 0, sizeof(*q_op));
+
+	for (op_id = 0; op_id < subop->ninstrs; op_id++) {
+		unsigned int offset, naddrs;
+		const u8 *addrs;
+
+		instr = &subop->instrs[op_id];
+
+		switch (instr->type) {
+		case NAND_OP_CMD_INSTR:
+			q_op->cmd_reg = qcom_op_cmd_mapping(nandc, instr->ctx.cmd.opcode, q_op);
+			q_op->rdy_delay_ns = instr->delay_ns;
+			break;
+
+		case NAND_OP_ADDR_INSTR:
+			offset = nand_subop_get_addr_start_off(subop, op_id);
+			naddrs = nand_subop_get_num_addr_cyc(subop, op_id);
+			addrs = &instr->ctx.addr.addrs[offset];
+			for (i = 0; i < MAX_ADDRESS_CYCLE; i++) {
+				if (i < 4)
+					q_op->addr1_reg |= (u32)addrs[i] << i * 8;
+				else
+					q_op->addr2_reg |= addrs[i];
+			}
+			q_op->rdy_delay_ns = instr->delay_ns;
+			break;
+
+		case NAND_OP_DATA_IN_INSTR:
+			q_op->data_instr = instr;
+			q_op->data_instr_idx = op_id;
+			q_op->rdy_delay_ns = instr->delay_ns;
+			fallthrough;
+		case NAND_OP_DATA_OUT_INSTR:
+			q_op->rdy_delay_ns = instr->delay_ns;
+			break;
+
+		case NAND_OP_WAITRDY_INSTR:
+			q_op->rdy_timeout_ms = instr->ctx.waitrdy.timeout_ms;
+			q_op->rdy_delay_ns = instr->delay_ns;
+			break;
+		}
+	}
+}
+
+static int qcom_check_op(struct nand_chip *chip,
+			 const struct nand_operation *op)
+{
+	const struct nand_op_instr *instr;
+	int op_id;
+
+	for (op_id = 0; op_id < op->ninstrs; op_id++) {
+		instr = &op->instrs[op_id];
+
+		switch (instr->type) {
+		case NAND_OP_CMD_INSTR:
+			if (instr->ctx.cmd.opcode == NAND_CMD_READCACHESEQ ||
+			    instr->ctx.cmd.opcode == NAND_CMD_READCACHEEND)
+				return -ENOTSUPP;
+			break;
+		case NAND_OP_ADDR_INSTR:
+			if (instr->ctx.addr.naddrs > MAX_ADDRESS_CYCLE)
+				return -ENOTSUPP;
+
+			break;
+		case NAND_OP_DATA_IN_INSTR:
+		case NAND_OP_DATA_OUT_INSTR:
+			if (instr->ctx.data.len > MAX_CHUNK_SIZE)
+				return -ENOTSUPP;
+			break;
+		default:
+			break;
+		}
+	}
+
+	return 0;
+}
+
+static int qcom_nand_exec_op(struct nand_chip *chip,
+			     const struct nand_operation *op,
+			bool check_only)
+{
+	if (check_only)
+		return qcom_check_op(chip, op);
+
+	return 0;
+}
+
 static const struct nand_controller_ops qcom_nandc_ops = {
 	.attach_chip = qcom_nand_attach_chip,
+	.exec_op = qcom_nand_exec_op,
 };
 
 static void qcom_nandc_unalloc(struct qcom_nand_controller *nandc)
-- 
2.17.1