[PATCH 10/12] mtd: rawnand: brcmnand: Add BCMBCA read data bus interface
Miquel Raynal
miquel.raynal at bootlin.com
Wed Jun 7 23:18:21 PDT 2023
Hi William,
william.zhang at broadcom.com wrote on Wed, 7 Jun 2023 13:24:23 -0700:
> Hi Miquel,
>
> On 06/07/2023 01:22 AM, Miquel Raynal wrote:
> > Hi William,
> >
> > william.zhang at broadcom.com wrote on Tue, 6 Jun 2023 16:12:50 -0700:
> >
> >> The BCMBCA broadband SoC integrates the NAND controller differently than
> >> STB, iProc and other SoCs. It has different endianness for NAND cache
> >> data and ONFI parameter data.
> >>
> >> Add a SoC read data bus shim for BCMBCA to meet the specific SoC need
> >> and performance improvement using the optimized memcpy function on NAND
> >> cache memory.
> >>
> >> Signed-off-by: William Zhang <william.zhang at broadcom.com>
> >> ---
> >>
> >> drivers/mtd/nand/raw/brcmnand/bcmbca_nand.c | 36 +++++++++++++++++
> >> drivers/mtd/nand/raw/brcmnand/brcmnand.c | 44 ++++++++++++++-------
> >> drivers/mtd/nand/raw/brcmnand/brcmnand.h | 2 +
> >> 3 files changed, 68 insertions(+), 14 deletions(-)
> >>
> >> diff --git a/drivers/mtd/nand/raw/brcmnand/bcmbca_nand.c b/drivers/mtd/nand/raw/brcmnand/bcmbca_nand.c
> >> index 7e48b6a0bfa2..899103a62c98 100644
> >> --- a/drivers/mtd/nand/raw/brcmnand/bcmbca_nand.c
> >> +++ b/drivers/mtd/nand/raw/brcmnand/bcmbca_nand.c
> >> @@ -26,6 +26,18 @@ enum {
> >> BCMBCA_CTLRDY = BIT(4),
> >> };
> >> >> +#if defined(CONFIG_ARM64)
> >> +#define ALIGN_REQ 8
> >> +#else
> >> +#define ALIGN_REQ 4
> >> +#endif
> >> +
> >> +static inline bool bcmbca_nand_is_buf_aligned(void *flash_cache, void *buffer)
> >> +{
> >> + return IS_ALIGNED((uintptr_t)buffer, ALIGN_REQ) &&
> >> + IS_ALIGNED((uintptr_t)flash_cache, ALIGN_REQ);
> >> +}
> >> +
> >> static bool bcmbca_nand_intc_ack(struct brcmnand_soc *soc)
> >> {
> >> struct bcmbca_nand_soc *priv =
> >> @@ -56,6 +68,29 @@ static void bcmbca_nand_intc_set(struct brcmnand_soc *soc, bool en)
> >> brcmnand_writel(val, mmio);
> >> }
> >> >> +static void bcmbca_read_data_bus(struct brcmnand_soc *soc,
> >> + void __iomem *flash_cache, u32 *buffer,
> >> + int fc_words, bool is_param)
> >> +{
> >> + int i;
> >> +
> >> + if (!is_param) {
> >> + /*
> >> + * memcpy can do unaligned aligned access depending on source
> >> + * and dest address, which is incompatible with nand cache. Fallback
> >> + * to the memcpy for io version
> >> + */
> >> + if (bcmbca_nand_is_buf_aligned(flash_cache, buffer))
> >> + memcpy((void *)buffer, (void *)flash_cache, fc_words * 4);
> >> + else
> >> + memcpy_fromio((void *)buffer, (void *)flash_cache, fc_words * 4);
> >> + } else {
> >> + /* Flash cache has same endian as the host for parameter pages */
> >> + for (i = 0; i < fc_words; i++, buffer++)
> >> + *buffer = __raw_readl(flash_cache + i * 4);
> >> + }
> >> +}
> >> +
> >> static int bcmbca_nand_probe(struct platform_device *pdev)
> >> {
> >> struct device *dev = &pdev->dev;
> >> @@ -75,6 +110,7 @@ static int bcmbca_nand_probe(struct platform_device *pdev)
> >> >> soc->ctlrdy_ack = bcmbca_nand_intc_ack;
> >> soc->ctlrdy_set_enabled = bcmbca_nand_intc_set;
> >> + soc->read_data_bus = bcmbca_read_data_bus;
> >> >> return brcmnand_probe(pdev, soc);
> >> }
> >> diff --git a/drivers/mtd/nand/raw/brcmnand/brcmnand.c b/drivers/mtd/nand/raw/brcmnand/brcmnand.c
> >> index d920e88c7f5b..656be4d73016 100644
> >> --- a/drivers/mtd/nand/raw/brcmnand/brcmnand.c
> >> +++ b/drivers/mtd/nand/raw/brcmnand/brcmnand.c
> >> @@ -814,6 +814,30 @@ static inline u32 edu_readl(struct brcmnand_controller *ctrl,
> >> return brcmnand_readl(ctrl->edu_base + offs);
> >> }
> >> >> +static inline void brcmnand_read_data_bus(struct brcmnand_controller *ctrl,
> >> + void __iomem *flash_cache, u32 *buffer,
> >> + int fc_words, bool is_param)
> >> +{
> >> + struct brcmnand_soc *soc = ctrl->soc;
> >> + int i;
> >> +
> >> + if (soc->read_data_bus) {
> >> + soc->read_data_bus(soc, flash_cache, buffer, fc_words, is_param);
> >> + } else {
> >> + if (!is_param) {
> >> + for (i = 0; i < fc_words; i++, buffer++)
> >> + *buffer = brcmnand_read_fc(ctrl, i);
> >> + } else {
> >> + for (i = 0; i < fc_words; i++)
> >> + /*
> >> + * Flash cache is big endian for parameter pages, at
> >> + * least on STB SoCs
> >> + */
> >> + buffer[i] = be32_to_cpu(brcmnand_read_fc(ctrl, i));
> >> + }
> >> + }
> >
> > Perhaps we could have a single function that is statically assigned at
> > probe time instead of a first helper with two conditions which calls in
> > one case another hook... This can be simplified I guess.
> >
> Well this will need to be done at the SoC specific implementation level (bcm<xxx>_nand.c) and each SoC will need to have either general data bus read func with is_param option or data_bus_read_page, data_bus_read_param.
You told me in case we would use exec_op we could avoid the param
cache. If that's true then the whole support can be simplified.
> Not sure how much this can be simplified... Or we have default
> implementation in brcmnand.c but then there is one condition check
> too. Page read is done at 512 bytes burst. One or two conditions
> check outside of the per 512 bytes read loop does not sounds too bad
> if performance is concern.
It is unreadable. That is my main concern.
>
> >> +}
> >> +
> >> static void brcmnand_clear_ecc_addr(struct brcmnand_controller *ctrl)
> >> {
> >> >> @@ -1811,20 +1835,11 @@ static void brcmnand_cmdfunc(struct nand_chip *chip, unsigned command,
> >> native_cmd == CMD_PARAMETER_CHANGE_COL) {
> >> /* Copy flash cache word-wise */
> >> u32 *flash_cache = (u32 *)ctrl->flash_cache;
> >> - int i;
> >> >> brcmnand_soc_data_bus_prepare(ctrl->soc, true);
> >> >> - /*
> >> - * Must cache the FLASH_CACHE now, since changes in
> >> - * SECTOR_SIZE_1K may invalidate it
> >> - */
> >> - for (i = 0; i < FC_WORDS; i++)
> >> - /*
> >> - * Flash cache is big endian for parameter pages, at
> >> - * least on STB SoCs
> >> - */
> >> - flash_cache[i] = be32_to_cpu(brcmnand_read_fc(ctrl, i));
> >> + brcmnand_read_data_bus(ctrl, ctrl->nand_fc, flash_cache,
> >> + FC_WORDS, true);
> >> >> brcmnand_soc_data_bus_unprepare(ctrl->soc, true);
> >> >> @@ -2137,7 +2152,7 @@ static int brcmnand_read_by_pio(struct mtd_info *mtd, struct nand_chip *chip,
> >> {
> >> struct brcmnand_host *host = nand_get_controller_data(chip);
> >> struct brcmnand_controller *ctrl = host->ctrl;
> >> - int i, j, ret = 0;
> >> + int i, ret = 0;
> >> >> brcmnand_clear_ecc_addr(ctrl);
> >> >> @@ -2150,8 +2165,9 @@ static int brcmnand_read_by_pio(struct mtd_info *mtd, struct nand_chip *chip,
> >> if (likely(buf)) {
> >> brcmnand_soc_data_bus_prepare(ctrl->soc, false);
> >> >> - for (j = 0; j < FC_WORDS; j++, buf++)
> >> - *buf = brcmnand_read_fc(ctrl, j);
> >> + brcmnand_read_data_bus(ctrl, ctrl->nand_fc, buf,
> >> + FC_WORDS, false);
> >> + buf += FC_WORDS;
> >> >> brcmnand_soc_data_bus_unprepare(ctrl->soc, false);
> >> }
> >> diff --git a/drivers/mtd/nand/raw/brcmnand/brcmnand.h b/drivers/mtd/nand/raw/brcmnand/brcmnand.h
> >> index f1f93d85f50d..88819bc395f8 100644
> >> --- a/drivers/mtd/nand/raw/brcmnand/brcmnand.h
> >> +++ b/drivers/mtd/nand/raw/brcmnand/brcmnand.h
> >> @@ -24,6 +24,8 @@ struct brcmnand_soc {
> >> void (*ctlrdy_set_enabled)(struct brcmnand_soc *soc, bool en);
> >> void (*prepare_data_bus)(struct brcmnand_soc *soc, bool prepare,
> >> bool is_param);
> >> + void (*read_data_bus)(struct brcmnand_soc *soc, void __iomem *flash_cache,
> >> + u32 *buffer, int fc_words, bool is_param);
> >> const struct brcmnand_io_ops *ops;
> >> };
> >> > >
> > Thanks,
> > Miquèl
> >
Thanks,
Miquèl
More information about the linux-mtd
mailing list