[PATCH v1] dt-bindings: nand: meson: Fix 'nand-rb' property

Miquel Raynal miquel.raynal at bootlin.com
Wed Jun 7 02:36:05 PDT 2023


Hi Arseniy,

avkrasnov at sberdevices.ru wrote on Wed, 7 Jun 2023 12:04:29 +0300:

> On 07.06.2023 12:08, Krzysztof Kozlowski wrote:
> > On 07/06/2023 10:57, Arseniy Krasnov wrote:  
> >>
> >>
> >> On 07.06.2023 11:53, Krzysztof Kozlowski wrote:  
> >>> On 07/06/2023 10:40, Arseniy Krasnov wrote:  
> >>>> Hello Miquel, 
> >>>>
> >>>> On 07.06.2023 10:58, Miquel Raynal wrote:
> >>>>  
> >>>>> Hi Arseniy,
> >>>>>
> >>>>> AVKrasnov at sberdevices.ru wrote on Tue, 6 Jun 2023 22:35:07 +0300:
> >>>>>  
> >>>>>> Add description of 'nand-rb' property. Use "Fixes" because this property
> >>>>>> must be supported since the beginning. For this controller 'nand-rb' is
> >>>>>> stored in the controller node (not in chip), because it has only single
> >>>>>> r/b wire for all chips.  
> >>>>>
> >>>>> Sorry if I mislead you in the first place, but you could definitely
> >>>>> have two chips and only one with RB wired. It needs to be defined in
> >>>>> the chips.  
> >>>>
> >>>> Ok, so to clarify: is it ok, that in bindings this property will be placed in the
> >>>> chip, but in driver, i'm trying to read it from the controller node (thus  in
> >>>> dts file it will be also in controller node)?  

The bindings and your driver internal representation are two different
things. Anyway, as mentioned above, wiring the RB line to one die and
not the other would be valid hardware design and would require the rb
property to be in the chip node. Please perform a per-chip property read
in the driver as well.

> >>>
> >>> No, because how would your DTS pass validation? I understand you did not
> >>> test the bindings, but this will improve, right?  
> >>
> >> Ok, i'll follow DTS layout in the driver, "test the bindings" You mean "make dt_binding_check"?  
> > 
> > Yes. They were sent without testing.
> > 
> > But please also test your DTS with dtbs_check.  
> 
> Got it!
> 
> Thanks, Arseniy
> 
> > 
> > 
> > Best regards,
> > Krzysztof
> >   


Thanks,
Miquèl



More information about the linux-mtd mailing list