[PATCH v4 10/11] mtd: spi-nor: spansion: switch s25hx_t to use vreg_offset for quad_enable()

[Tudor Ambarus]

All s25hx_t flashes have single or multi chip flavors and already use
n_dice and vreg_offset in cypress_nor_sr_ready_and_clear. Switch s25hx_t
to always use vreg_offset for the quad_enable() method, so that we use
the same code base for both single and multi chip package flashes.

Signed-off-by: Tudor Ambarus <tudor.ambarus at linaro.org>
---
 drivers/mtd/spi-nor/spansion.c | 18 +++++++-----------
 1 file changed, 7 insertions(+), 11 deletions(-)

diff --git a/drivers/mtd/spi-nor/spansion.c b/drivers/mtd/spi-nor/spansion.c
index 30a3ffbfa381..6abef5b515a1 100644
--- a/drivers/mtd/spi-nor/spansion.c
+++ b/drivers/mtd/spi-nor/spansion.c
@@ -24,8 +24,6 @@
 #define SPINOR_REG_CYPRESS_STR1V					\
 	(SPINOR_REG_CYPRESS_VREG + SPINOR_REG_CYPRESS_STR1)
 #define SPINOR_REG_CYPRESS_CFR1			0x2
-#define SPINOR_REG_CYPRESS_CFR1V					\
-	(SPINOR_REG_CYPRESS_VREG + SPINOR_REG_CYPRESS_CFR1)
 #define SPINOR_REG_CYPRESS_CFR1_QUAD_EN		BIT(1)	/* Quad Enable */
 #define SPINOR_REG_CYPRESS_CFR2			0x3
 #define SPINOR_REG_CYPRESS_CFR2V					\
@@ -348,10 +346,6 @@ static int cypress_nor_quad_enable_volatile(struct spi_nor *nor)
 	u8 i;
 	int ret;
 
-	if (!params->n_dice)
-		return cypress_nor_quad_enable_volatile_reg(nor,
-						SPINOR_REG_CYPRESS_CFR1V);
-
 	for (i = 0; i < params->n_dice; i++) {
 		addr = params->vreg_offset[i] + SPINOR_REG_CYPRESS_CFR1;
 		ret = cypress_nor_quad_enable_volatile_reg(nor, addr);
@@ -657,15 +651,17 @@ static int s25hx_t_late_init(struct spi_nor *nor)
 {
 	struct spi_nor_flash_parameter *params = nor->params;
 
+	if (!params->n_dice || !params->vreg_offset) {
+		dev_err(nor->dev, "%s failed. The volatile register offset could not be retrieved from SFDP.\n",
+			__func__);
+		return -EOPNOTSUPP;
+	}
+
 	/* Fast Read 4B requires mode cycles */
 	params->reads[SNOR_CMD_READ_FAST].num_mode_clocks = 8;
-
+	params->ready = cypress_nor_sr_ready_and_clear;
 	cypress_nor_ecc_init(nor);
 
-	/* Replace ready() with multi die version */
-	if (params->n_dice)
-		params->ready = cypress_nor_sr_ready_and_clear;
-
 	return 0;
 }
 
-- 
2.34.1