[RESEND PATCH v3 07/11] mtd: spi-nor: spansion: add octal DTR support in RD_ANY_REG_OP

[Tudor Ambarus]

From: Takahiro Kuwano <Takahiro.Kuwano at infineon.com>

S28HS02GT uses RD_ANY_REG_OP to read status of each die. In Octal DTR
mode, RD_ANY_REG_OP needs dummy cycles (same as params->rdsr_dummy) and
data length should be 2.

Signed-off-by: Takahiro Kuwano <Takahiro.Kuwano at infineon.com>
---
 drivers/mtd/spi-nor/spansion.c | 8 +++++++-
 1 file changed, 7 insertions(+), 1 deletion(-)

diff --git a/drivers/mtd/spi-nor/spansion.c b/drivers/mtd/spi-nor/spansion.c
index 28d0a995f3b9..2fc3e65686b3 100644
--- a/drivers/mtd/spi-nor/spansion.c
+++ b/drivers/mtd/spi-nor/spansion.c
@@ -104,11 +104,17 @@ static void spansion_nor_clear_sr(struct spi_nor *nor)
 
 static int cypress_nor_sr_ready_and_clear_reg(struct spi_nor *nor, u64 addr)
 {
+	struct spi_nor_flash_parameter *params = nor->params;
 	struct spi_mem_op op =
-		CYPRESS_NOR_RD_ANY_REG_OP(nor->params->addr_mode_nbytes, addr,
+		CYPRESS_NOR_RD_ANY_REG_OP(params->addr_mode_nbytes, addr,
 					  0, nor->bouncebuf);
 	int ret;
 
+	if (nor->reg_proto == SNOR_PROTO_8_8_8_DTR) {
+		op.dummy.nbytes = params->rdsr_dummy;
+		op.data.nbytes = 2;
+	}
+
 	ret = spi_nor_read_any_reg(nor, &op, nor->reg_proto);
 	if (ret)
 		return ret;
-- 
2.34.1