[PATCH 0/4] Add a property to override the quad mode

Krzysztof Kozlowski krzysztof.kozlowski at linaro.org
Tue Aug 15 12:19:34 PDT 2023


On 15/08/2023 19:21, Hsin-Yi Wang wrote:
> On Tue, Aug 15, 2023 at 11:59 PM Michael Walle <michael at walle.cc> wrote:
>>
>> Hi,
>>
>>> On gigadevice gd25lq64c, the quad mode is enabled after BFPT is parsed.
>>> According to datasheet[1], Quad enable (QE) bit needs to be set to 0 to
>>> use write protection (WP) pin. It also recommends setting default value of
>>> QE to 0 to avoid a potential short issue.
>>
>> So you are using either dual or single io mode. Why can't you use the device tree property spi-{tx,rx}-bus-width?
> 
> I tried setting spi-tx-bus-width and spi-rx-bus-width to either 0 or 1
> and WP still doesn't work.
> For this chip, quad_enable will be set to spi_nor_sr2_bit1_quad_enable
> (QER flag is BFPT_DWORD15_QER_SR2_BIT1_BUGGY)[1]
> 
> spi_nor_write_sr_and_check() calls
> spi_nor_write_16bit_sr_and_check()[2] and the function sets QE bit if
> quad_enable is not NULL.
> 
> [1] https://elixir.bootlin.com/linux/latest/source/drivers/mtd/spi-nor/sfdp.c#L575
> [2] https://elixir.bootlin.com/linux/latest/source/drivers/mtd/spi-nor/core.c#L879
> 
> Setting spi-{tx,rx}-bus-width still falls to this function and cases.

with tx/rx bus width = 2, how quad mode is still possible? IOW, why do
you need new property? You wrote here about driver, but I ask about
bindings.

Best regards,
Krzysztof




More information about the linux-mtd mailing list