[PATCH v4 5/5] mtd: ubi: block: add option to enable scanning for partitions

[Daniel Golle]

Add Kconfig option CONFIG_MTD_UBI_BLOCK_PARTITIONS and enable block
partition parsers on ubiblock devices in case it is selected.

Signed-off-by: Daniel Golle <daniel at makrotopia.org>
---
 drivers/mtd/ubi/Kconfig | 10 ++++++++++
 drivers/mtd/ubi/block.c |  5 ++++-
 2 files changed, 14 insertions(+), 1 deletion(-)

diff --git a/drivers/mtd/ubi/Kconfig b/drivers/mtd/ubi/Kconfig
index 2ed77b7b3fcb..491330e42ab2 100644
--- a/drivers/mtd/ubi/Kconfig
+++ b/drivers/mtd/ubi/Kconfig
@@ -104,4 +104,14 @@ config MTD_UBI_BLOCK
 
 	   If in doubt, say "N".
 
+config MTD_UBI_BLOCK_PARTITIONS
+	bool "Scan UBI block devices for partitions"
+	default y if FIT_PARTITION
+	depends on MTD_UBI_BLOCK
+	help
+	  Scan UBI block devices for partitions (ie. MBR, GPT, uImage.FIT, ...).
+
+	  Unless your UBI volumes contain sub-partitions mapped using a partition
+	  table, say no.
+
 endif # MTD_UBI
diff --git a/drivers/mtd/ubi/block.c b/drivers/mtd/ubi/block.c
index 75eaecc8639f..d9baa99ca093 100644
--- a/drivers/mtd/ubi/block.c
+++ b/drivers/mtd/ubi/block.c
@@ -430,7 +430,10 @@ int ubiblock_create(struct ubi_volume_info *vi)
 		ret = -ENODEV;
 		goto out_cleanup_disk;
 	}
-	gd->flags |= GENHD_FL_NO_PART;
+
+	if (!IS_ENABLED(CONFIG_MTD_UBI_BLOCK_PARTITIONS))
+		gd->flags |= GENHD_FL_NO_PART;
+
 	gd->private_data = dev;
 	sprintf(gd->disk_name, "ubiblock%d_%d", dev->ubi_num, dev->vol_id);
 	set_capacity(gd, disk_capacity);
-- 
2.38.1