[RFC PATCH 3/6] mtd: spi-nor: core: run calibration when initialization is done

Miquel Raynal miquel.raynal at bootlin.com
Tue May 17 07:02:26 PDT 2022


Hi Pratyush,

p.yadav at ti.com wrote on Fri, 12 Mar 2021 00:42:13 +0530:

> Once the flash is initialized tell the controller it can run
> calibration procedures if needed. This can be useful when calibration is
> needed to run at higher clock speeds.
> 
> Signed-off-by: Pratyush Yadav <p.yadav at ti.com>
> ---
>  drivers/mtd/spi-nor/core.c | 12 ++++++++++--
>  1 file changed, 10 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/mtd/spi-nor/core.c b/drivers/mtd/spi-nor/core.c
> index 88888df009f0..e0cbcaf1be89 100644
> --- a/drivers/mtd/spi-nor/core.c
> +++ b/drivers/mtd/spi-nor/core.c
> @@ -3650,6 +3650,7 @@ static int spi_nor_probe(struct spi_mem *spimem)
>  	 * checking what's really supported using spi_mem_supports_op().
>  	 */
>  	const struct spi_nor_hwcaps hwcaps = { .mask = SNOR_HWCAPS_ALL };
> +	struct spi_mem_op op;
>  	char *flash_name;
>  	int ret;
>  
> @@ -3709,8 +3710,15 @@ static int spi_nor_probe(struct spi_mem *spimem)
>  	if (ret)
>  		return ret;
>  
> -	return mtd_device_register(&nor->mtd, data ? data->parts : NULL,
> -				   data ? data->nr_parts : 0);
> +	ret = mtd_device_register(&nor->mtd, data ? data->parts : NULL,
> +				  data ? data->nr_parts : 0);
> +	if (ret)
> +		return ret;
> +
> +	op = spi_nor_spimem_get_read_op(nor);

Isn't this too specific? I really don't know much about spi-nors, but I
find odd to have this op being created here, why not moving this into
the _do_calibration() helper?

> +	spi_mem_do_calibration(nor->spimem, &op);

A warning/info upon calibration error (not on the absence of the hook)
would be nice?

> +
> +	return 0;
>  }
>  
>  static int spi_nor_remove(struct spi_mem *spimem)

Otherwise I like the overall idea.

Thanks,
Miquèl



More information about the linux-mtd mailing list