mtd: spi-nor: fix spi_nor_spimem_setup_op() call in spi_nor_erase_{sector,chip}()

[Alexander Sverdlin]

Hello Patrice,

thanks for the patch!
It fixes mt25qu256a erase in my tests.

On 29/06/2022 15:30, patrice.chotard at foss.st.com wrote:
> From: Patrice Chotard <patrice.chotard at foss.st.com>
> 
> For erase operations, reg_proto must be used as indicated in
> struct spi_nor description in spi-nor.h.
> 
> This issue was found when DT property spi-tx-bus-width is set to 4.
> In this case the spi_mem_op->addr.buswidth is set to 4 for erase command
> which is not correct.
> 
> Tested on stm32mp157c-ev1 board with mx66l51235f spi-nor.
> 
> Fixes: 0e30f47232ab ("mtd: spi-nor: add support for DTR protocol")
> Signed-off-by: Patrice Chotard <patrice.chotard at foss.st.com>

Tested-by: Alexander Sverdlin <alexander.sverdlin at nokia.com>

> ---
>  drivers/mtd/spi-nor/core.c | 4 ++--
>  1 file changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/mtd/spi-nor/core.c b/drivers/mtd/spi-nor/core.c
> index 502967c76c5f..61027330848f 100644
> --- a/drivers/mtd/spi-nor/core.c
> +++ b/drivers/mtd/spi-nor/core.c
> @@ -972,7 +972,7 @@ static int spi_nor_erase_chip(struct spi_nor *nor)
>  	if (nor->spimem) {
>  		struct spi_mem_op op = SPI_NOR_CHIP_ERASE_OP;
>  
> -		spi_nor_spimem_setup_op(nor, &op, nor->write_proto);
> +		spi_nor_spimem_setup_op(nor, &op, nor->reg_proto);
>  
>  		ret = spi_mem_exec_op(nor->spimem, &op);
>  	} else {
> @@ -1115,7 +1115,7 @@ int spi_nor_erase_sector(struct spi_nor *nor, u32 addr)
>  			SPI_NOR_SECTOR_ERASE_OP(nor->erase_opcode,
>  						nor->addr_width, addr);
>  
> -		spi_nor_spimem_setup_op(nor, &op, nor->write_proto);
> +		spi_nor_spimem_setup_op(nor, &op, nor->reg_proto);
>  
>  		return spi_mem_exec_op(nor->spimem, &op);
>  	} else if (nor->controller_ops->erase) {

-- 
Best regards,
Alexander Sverdlin.