[PATCH 1/2] mtd: spi-nor: When a flash memory is missing do not report an error

[Andre Przywara]

On Fri, 15 Jul 2022 21:28:57 -0500
Samuel Holland <samuel at sholland.org> wrote:

Hi,

> On 7/15/22 7:20 AM, Andre Przywara wrote:
> >>>> However, when the board is designed for a specific kind of device which
> >>>> is not always present, and the kernel can detect the device, it is
> >>>> perfectly fine to describe it.
> >>>>
> >>>> The alternative is to not use the device at all, even when present,
> >>>> which is kind of useless.    
> >>>
> >>> Or let the bootloader update your device tree and disable the device
> >>> if it's not there?    
> > 
> > Yes, this is what I was suggesting already: U-Boot can do the job, because
> > a U-Boot build is device specific, and we can take certain risks that the
> > generic and single-image kernel wants to avoid.
> > In this case we know that there is a SPI flash footprint, and it does no
> > harm in trying to check on CS0. So I was thinking about introducing a
> > U-Boot Kconfig variable to probe for and potentially disable the SPI flash
> > DT node. We would set this variable in defconfigs of boards with optional
> > SPI flash.  
> 
> To support the "does no harm" assertion: the Allwinner Boot ROM will probe for
> NOR flash (and possibly SPI NAND) on SPI0 + CS0 if no bootable MMC device is
> found. So the board designer must already assume that JEDEC Read ID commands
> will be sent over that bus.
> 
> >> But then it must be in the device tree?  
> > 
> > However this indeed means that the SPI flash DT node must be in and enabled
> > in the DT, because we (try hard to) only use original Linux DT files, and
> > DTs must have been reviewed through the kernel ML first. The U-Boot driver
> > relies on the DT as well, so the official kernel DT copy would need to come
> > with that node enabled. Ideally U-Boot would disable it, if needed, and
> > the kernel error message would never appear.  
> 
> I don't think this works for newer SoCs where the Boot ROM supports both NOR and
> SPI NAND. If the board is sold with the flash chip unpopulated, the user could
> install either kind of chip. So we cannot statically assume which binding will
> be used. We would need to add a node with the right compatible string after
> probing for both in the bootloader.

If a *user* decides to *change* the board, it's up to the user
to make sure the DT matches. Overlays are the typical answer, or people
change the DT before they build U-Boot. If someone decides to hack
their board, they have to take care of the respective DT description
hack as well.

This case here is about the *vendor* shipping different versions of the
board, which I think is a different case. Technically we now would need
two DTs: one with, one without the SPI flash node, and let the user
decide which one to include in U-Boot at build time, depending on which
version they have.

What I was suggesting is a U-Boot config switch, which would only be
enabled on those boards where we have this situation (OPi Zero):
That avoids dangerous situations (because we know it's safe *on this
particular board*), and avoids the hassle of shipping two firmware
versions.

Cheers,
Andre