[PATCH 1/3] mtd: rawnand: qcom: Add support for status pipe

[mdalam at codeaurora.org]

On 2021-09-15 15:27, Md Sadre Alam wrote:
> From QPIC V2.0 onwards there is a separate pipe
> to read status of each code word, called "status" pipe.
> 
> "status" pipe will use to read CW status in case of
> enhanced read mode like page scope read, multi page read.
> 
> Signed-off-by: Md Sadre Alam <mdalam at codeaurora.org>
> ---
>  drivers/mtd/nand/raw/qcom_nandc.c | 14 ++++++++++++++
>  1 file changed, 14 insertions(+)
> 
> diff --git a/drivers/mtd/nand/raw/qcom_nandc.c
> b/drivers/mtd/nand/raw/qcom_nandc.c
> index 04e6f7b..42c6291 100644
> --- a/drivers/mtd/nand/raw/qcom_nandc.c
> +++ b/drivers/mtd/nand/raw/qcom_nandc.c
> @@ -389,6 +389,7 @@ struct qcom_nand_controller {
>  			struct dma_chan *tx_chan;
>  			struct dma_chan *rx_chan;
>  			struct dma_chan *cmd_chan;
> +			struct dma_chan *sts_chan;
>  		};
> 
>  		/* will be used only by EBI2 for ADM DMA */
> @@ -2737,6 +2738,11 @@ static void qcom_nandc_unalloc(struct
> qcom_nand_controller *nandc)
> 
>  		if (nandc->cmd_chan)
>  			dma_release_channel(nandc->cmd_chan);
> +
> +		if (nandc->props->qpic_v2) {
> +			if (nandc->sts_chan)
> +				dma_release_channel(nandc->sts_chan);
> +		}
>  	} else {
>  		if (nandc->chan)
>  			dma_release_channel(nandc->chan);
> @@ -2815,6 +2821,14 @@ static int qcom_nandc_alloc(struct
> qcom_nand_controller *nandc)
>  			goto unalloc;
>  		}
> 
> +		if (nandc->props->qpic_v2) {
> +			nandc->sts_chan = dma_request_slave_channel(nandc->dev, "sts");
> +			if (!nandc->sts_chan) {
> +				dev_err(nandc->dev, "failed to request sts channel\n");
> +				return -ENODEV;
> +			}
> +		}
> +
>  		/*
>  		 * Initially allocate BAM transaction to read ONFI param page.
>  		 * After detecting all the devices, this BAM transaction will

Ping! Please provide me some updates on this patch.