[RFC PATCH 1/2] mtd: rawnand: gpmi: Remove explicit default gpmi clock setting for i.MX6

[Christian Eggers]

On Tuesday, 12 October 2021, 11:02:23 CEST, Stefan Riedmueller wrote:
> There is no need to explicitly set the default gpmi clock rate during
> boot for the i.MX 6 since this is done during nand_detect anyway.
> 
> Signed-off-by: Stefan Riedmueller <s.riedmueller at phytec.de>
> ---
>  drivers/mtd/nand/raw/gpmi-nand/gpmi-nand.c | 9 ---------
>  1 file changed, 9 deletions(-)
> 
> diff --git a/drivers/mtd/nand/raw/gpmi-nand/gpmi-nand.c b/drivers/mtd/nand/raw/gpmi-nand/gpmi-nand.c
> index 4d08e4ab5c1b..a1f7000f033e 100644
> --- a/drivers/mtd/nand/raw/gpmi-nand/gpmi-nand.c
> +++ b/drivers/mtd/nand/raw/gpmi-nand/gpmi-nand.c
> @@ -1034,15 +1034,6 @@ static int gpmi_get_clks(struct gpmi_nand_data *this)
>  		r->clock[i] = clk;
>  	}
>  
> -	if (GPMI_IS_MX6(this))
> -		/*
> -		 * Set the default value for the gpmi clock.
> -		 *
> -		 * If you want to use the ONFI nand which is in the
> -		 * Synchronous Mode, you should change the clock as you need.
> -		 */
> -		clk_set_rate(r->clock[0], 22000000);
> -
>  	return 0;
>  
>  err_clock:
> 

Tested-by: Christian Eggers <ceggers at arri.de>  # on i.MX6ULL with MT29F4G08ABADAH4
Cc: stable at vger.kernel.org