[PATCH 2/3] mtd: spi-nor: intel-spi: Convert to SPI MEM

[Pratyush Yadav]

On 30/09/21 01:07PM, Mika Westerberg wrote:
> The preferred way to implement SPI-NOR controller drivers is through SPI
> subsubsystem utilizing the SPI MEM core functions. This converts the
> Intel SPI flash controller driver over the SPI MEM by moving the driver
> from SPI-NOR subsystem to SPI subsystem and in one go make it use the
> SPI MEM functions. The driver name will be changed from intel-spi to
> spi-intel to match the convention used in the SPI subsystem.
> 
> Signed-off-by: Mika Westerberg <mika.westerberg at linux.intel.com>
> ---
>  drivers/mtd/spi-nor/controllers/Kconfig       |  36 ---
>  drivers/mtd/spi-nor/controllers/Makefile      |   3 -
>  drivers/mtd/spi-nor/controllers/intel-spi.h   |  21 --
>  drivers/spi/Kconfig                           |  38 +++
>  drivers/spi/Makefile                          |   3 +
>  .../intel-spi-pci.c => spi/spi-intel-pci.c}   |  20 +-
>  .../spi-intel-platform.c}                     |  21 +-
>  .../intel-spi.c => spi/spi-intel.c}           | 300 +++++++++++-------
>  drivers/spi/spi-intel.h                       |  19 ++
>  include/linux/mfd/lpc_ich.h                   |   2 +-
>  .../x86/{intel-spi.h => spi-intel.h}          |   6 +-
>  11 files changed, 252 insertions(+), 217 deletions(-)
>  delete mode 100644 drivers/mtd/spi-nor/controllers/intel-spi.h
>  rename drivers/{mtd/spi-nor/controllers/intel-spi-pci.c => spi/spi-intel-pci.c} (86%)
>  rename drivers/{mtd/spi-nor/controllers/intel-spi-platform.c => spi/spi-intel-platform.c} (65%)
>  rename drivers/{mtd/spi-nor/controllers/intel-spi.c => spi/spi-intel.c} (80%)
>  create mode 100644 drivers/spi/spi-intel.h
>  rename include/linux/platform_data/x86/{intel-spi.h => spi-intel.h} (89%)
> 
[...]
> +static bool intel_spi_supports_mem_op(struct spi_mem *mem,
> +				      const struct spi_mem_op *op)
> +{
> +	struct intel_spi *ispi = spi_master_get_devdata(mem->spi->master);
>  
> -			offs += erase_size;
> -			len -= erase_size;
> +	if (op->cmd.dtr)
> +		return false;
> +
> +	if (ispi->swseq_reg && ispi->locked) {
> +		int i;
> +
> +		for (i = 0; i < ARRAY_SIZE(ispi->opcodes); i++) {
> +			if (ispi->opcodes[i] == op->cmd.opcode)
> +				return true;
>  		}
>  
> -		return 0;
> +		return false;
>  	}
>  
> -	/* Not needed with HW sequencer erase, make sure it is cleared */
> -	ispi->atomic_preopcode = 0;
> +	switch (op->cmd.opcode) {
> +	case SPINOR_OP_RDID:
> +	case SPINOR_OP_RDSR:
> +	case SPINOR_OP_WRSR:
> +		return true;
>  
> -	while (len > 0) {
> -		writel(offs, ispi->base + FADDR);
> +	case SPINOR_OP_READ:
> +	case SPINOR_OP_READ_FAST:
> +	case SPINOR_OP_READ_4B:
> +	case SPINOR_OP_READ_FAST_4B:
> +		return true;

I think the checks need to be stricter here. For example, I don't see 
you pass in protocol width (dual, quad, octal, etc.) to intel_spi_read() 
so I assume it can only do a certain protocol. You need to make sure 
that other protocols are rejected here.

Similarly, you also don't pass in dummy cycles to intel_spi_read(), so I 
assume it can only do a fix number of dummy cycles. Need to make sure 
you reject unsupported ones. Same for other opcodes/cases.

>  
> -		val = readl(ispi->base + HSFSTS_CTL);
> -		val &= ~(HSFSTS_CTL_FDBC_MASK | HSFSTS_CTL_FCYCLE_MASK);
> -		val |= HSFSTS_CTL_AEL | HSFSTS_CTL_FCERR | HSFSTS_CTL_FDONE;
> -		val |= cmd;
> -		val |= HSFSTS_CTL_FGO;
> -		writel(val, ispi->base + HSFSTS_CTL);
> +	case SPINOR_OP_PP:
> +	case SPINOR_OP_PP_4B:
> +	case SPINOR_OP_WREN:
> +	case SPINOR_OP_WRDI:
> +		return true;
>  
> -		ret = intel_spi_wait_hw_busy(ispi);
> -		if (ret)
> -			return ret;
> +	case SPINOR_OP_SE:
> +	case SPINOR_OP_SE_4B:
> +		return ispi->erase_64k;
>  
> -		status = readl(ispi->base + HSFSTS_CTL);
> -		if (status & HSFSTS_CTL_FCERR)
> -			return -EIO;
> -		else if (status & HSFSTS_CTL_AEL)
> -			return -EACCES;
> +	case SPINOR_OP_BE_4K:
> +	case SPINOR_OP_BE_4K_4B:
> +		return true;
> +	}
> +
> +	return false;
> +}
>  
> -		offs += erase_size;
> -		len -= erase_size;
> +static int intel_spi_exec_mem_op(struct spi_mem *mem, const struct spi_mem_op *op)
> +{
> +	struct intel_spi *ispi = spi_master_get_devdata(mem->spi->master);
> +	size_t nbytes = op->data.nbytes;
> +	u8 opcode = op->cmd.opcode;
> +
> +	if (op->addr.nbytes) {
> +		if  (op->data.dir == SPI_MEM_DATA_IN)
> +			return intel_spi_read(ispi, op->addr.val, nbytes,
> +					      op->data.buf.in);
> +		else if (op->data.dir == SPI_MEM_DATA_OUT)
> +			return intel_spi_write(ispi, op->addr.val, nbytes,
> +					       op->data.buf.out);
> +		else if (op->data.dir == SPI_MEM_NO_DATA)
> +			return intel_spi_erase(ispi, opcode, op->addr.val);
> +	} else {
> +		if  (op->data.dir == SPI_MEM_DATA_IN)
> +			return intel_spi_read_reg(ispi, opcode, op->data.buf.in,
> +						  nbytes);
> +		else if (op->data.dir == SPI_MEM_DATA_OUT)
> +			return intel_spi_write_reg(ispi, opcode, op->data.buf.out,
> +						   nbytes);
> +		else if (op->data.dir == SPI_MEM_NO_DATA)
> +			return intel_spi_write_reg(ispi, opcode, NULL, 0);
>  	}
>  
> -	return 0;
> +	return -EINVAL;
> +}
> +
[...]

-- 
Regards,
Pratyush Yadav
Texas Instruments Inc.