[PATCH 1/2] mtd: spi-nor: sfdp: save a copy of the SFDP data
Pratyush Yadav
p.yadav at ti.com
Mon Mar 22 14:21:43 GMT 2021
Hi Michael,
On 18/03/21 10:24AM, Michael Walle wrote:
> Due to possible mode switching to 8D-8D-8D, it might not be possible to
> read the SFDP after the initial probe. To be able to dump the SFDP via
> sysfs afterwards, make a complete copy of it.
>
> Signed-off-by: Michael Walle <michael at walle.cc>
> ---
> drivers/mtd/spi-nor/core.h | 10 ++++++++
> drivers/mtd/spi-nor/sfdp.c | 49 +++++++++++++++++++++++++++++++++++++
> include/linux/mtd/spi-nor.h | 3 +++
> 3 files changed, 62 insertions(+)
>
> diff --git a/drivers/mtd/spi-nor/core.h b/drivers/mtd/spi-nor/core.h
> index 4a3f7f150b5d..668f22011b1d 100644
> --- a/drivers/mtd/spi-nor/core.h
> +++ b/drivers/mtd/spi-nor/core.h
> @@ -407,6 +407,16 @@ struct spi_nor_manufacturer {
> const struct spi_nor_fixups *fixups;
> };
>
> +/**
> + * struct sfdp - SFDP data
> + * @num_dwords: number of entries in the dwords array
> + * @dwords: array of double words of the SFDP data
> + */
> +struct sfdp {
> + size_t num_dwords;
> + u32 *dwords;
> +};
> +
> /* Manufacturer drivers. */
> extern const struct spi_nor_manufacturer spi_nor_atmel;
> extern const struct spi_nor_manufacturer spi_nor_catalyst;
> diff --git a/drivers/mtd/spi-nor/sfdp.c b/drivers/mtd/spi-nor/sfdp.c
> index 25142ec4737b..2b6c96e02532 100644
> --- a/drivers/mtd/spi-nor/sfdp.c
> +++ b/drivers/mtd/spi-nor/sfdp.c
> @@ -16,6 +16,7 @@
> (((p)->parameter_table_pointer[2] << 16) | \
> ((p)->parameter_table_pointer[1] << 8) | \
> ((p)->parameter_table_pointer[0] << 0))
> +#define SFDP_PARAM_HEADER_PARAM_LEN(p) ((p)->length * 4)
>
> #define SFDP_BFPT_ID 0xff00 /* Basic Flash Parameter Table */
> #define SFDP_SECTOR_MAP_ID 0xff81 /* Sector Map Table */
> @@ -1263,6 +1264,8 @@ int spi_nor_parse_sfdp(struct spi_nor *nor,
> struct sfdp_parameter_header *param_headers = NULL;
> struct sfdp_header header;
> struct device *dev = nor->dev;
> + struct sfdp *sfdp;
> + size_t sfdp_size;
> size_t psize;
> int i, err;
>
> @@ -1285,6 +1288,9 @@ int spi_nor_parse_sfdp(struct spi_nor *nor,
> bfpt_header->major != SFDP_JESD216_MAJOR)
> return -EINVAL;
>
> + sfdp_size = SFDP_PARAM_HEADER_PTP(bfpt_header) +
> + SFDP_PARAM_HEADER_PARAM_LEN(bfpt_header);
> +
> /*
> * Allocate memory then read all parameter headers with a single
> * Read SFDP command. These parameter headers will actually be parsed
> @@ -1311,6 +1317,49 @@ int spi_nor_parse_sfdp(struct spi_nor *nor,
> }
> }
>
> + /*
> + * Cache the complete SFDP data. It is not (easily) possible to fetch
> + * SFDP after probe time and we need it for the sysfs access.
> + */
> + for (i = 0; i < header.nph; i++) {
> + param_header = ¶m_headers[i];
> + sfdp_size = max_t(size_t, sfdp_size,
> + SFDP_PARAM_HEADER_PTP(param_header) +
> + SFDP_PARAM_HEADER_PARAM_LEN(param_header));
*sigh* If BFPT header was not made a part of the main SFDP header, two
"sfdp_size = ..." would not be needed, and we could do it all in one
place.
You can do that refactor if you're feeling like it, but I won't insist
on it.
> + }
> +
> + /*
> + * Limit the total size to a reasonable value to avoid allocating too
> + * much memory just of because the flash returned some insane values.
> + */
> + if (sfdp_size > PAGE_SIZE) {
> + dev_dbg(dev, "SFDP data (%zu) too big, truncating\n",
> + sfdp_size);
> + sfdp_size = PAGE_SIZE;
Ok. 4K should be large enough for any reasonable SFDP table.
> + }
> +
> + sfdp = devm_kzalloc(dev, sizeof(*sfdp), GFP_KERNEL);
> + if (!sfdp) {
> + err = -ENOMEM;
> + goto exit;
> + }
I assume you made nor->sfdp a pointer and not an embedded struct so it
can easily indicate if SFDP was found or not, correct?
> +
> + sfdp->num_dwords = DIV_ROUND_UP(sfdp_size, sizeof(*sfdp->dwords));
The SFDP spec says that Parameter Table Pointer should be DWORD aligned
and Parameter Table length is specified in number of DWORDs. So,
sfdp_size should always be a multiple of 4. Any SFDP table where this is
not true is an invalid one.
Also, the spec says "Device behavior when the Read SFDP command crosses
the SFDP structure boundary is not defined".
So I think this should be a check for alignment instead of a round-up.
> + sfdp->dwords = devm_kcalloc(dev, sfdp->num_dwords,
> + sizeof(*sfdp->dwords), GFP_KERNEL);
> + if (!sfdp->dwords) {
> + err = -ENOMEM;
Free sfdp here since it won't be used any longer.
> + goto exit;
> + }
> +
> + err = spi_nor_read_sfdp_dma_unsafe(nor, 0, sfdp_size, sfdp->dwords);
> + if (err < 0) {
> + dev_dbg(dev, "failed to read SFDP data\n");
> + goto exit;
Free sfdp and sfdp->dwords here since they won't be used any longer.
> + }
> +
> + nor->sfdp = sfdp;
> +
> /*
> * Check other parameter headers to get the latest revision of
> * the basic flash parameter table.
> diff --git a/include/linux/mtd/spi-nor.h b/include/linux/mtd/spi-nor.h
> index a0d572855444..55c550208949 100644
> --- a/include/linux/mtd/spi-nor.h
> +++ b/include/linux/mtd/spi-nor.h
> @@ -351,6 +351,7 @@ enum spi_nor_cmd_ext {
> struct flash_info;
> struct spi_nor_manufacturer;
> struct spi_nor_flash_parameter;
> +struct sfdp;
nor->sfdp is a pointer. This should not be needed.
>
> /**
> * struct spi_nor - Structure for defining the SPI NOR layer
> @@ -375,6 +376,7 @@ struct spi_nor_flash_parameter;
> * @read_proto: the SPI protocol for read operations
> * @write_proto: the SPI protocol for write operations
> * @reg_proto: the SPI protocol for read_reg/write_reg/erase operations
> + * @sfdp: the SFDP data of the flash
> * @controller_ops: SPI NOR controller driver specific operations.
> * @params: [FLASH-SPECIFIC] SPI NOR flash parameters and settings.
> * The structure includes legacy flash parameters and
> @@ -404,6 +406,7 @@ struct spi_nor {
> bool sst_write_second;
> u32 flags;
> enum spi_nor_cmd_ext cmd_ext_type;
> + struct sfdp *sfdp;
>
> const struct spi_nor_controller_ops *controller_ops;
>
> --
> 2.20.1
>
--
Regards,
Pratyush Yadav
Texas Instruments Inc.
More information about the linux-mtd
mailing list