[PATCH 04/20] mtd: nand: ecc-bch: Stop exporting the private structure

[Miquel Raynal]

Hi Adam,

Adam Ford <aford173 at gmail.com> wrote on Tue, 19 Jan 2021 09:49:36 -0600:

> On Tue, Jan 19, 2021 at 8:36 AM Miquel Raynal <miquel.raynal at bootlin.com> wrote:
> >
> > Hi Adam,
> >  
> > > > ---8<---
> > > >
> > > > Author: Miquel Raynal <miquel.raynal at bootlin.com>
> > > > Date:   Tue Jan 19 12:27:07 2021 +0100
> > > >
> > > >     wip: fix omap
> > > >
> > > >     Signed-off-by: Miquel Raynal <miquel.raynal at bootlin.com>
> > > >  
> > > Thanks for fixing this.
> > >
> > > I tested your patch, and I no longer get a Panic and the MTD device
> > > appears to appear correctly:
> > >
> > > mtdoops: mtd device (mtddev=name/number) must be supplied
> > > omap2-nand 30000000.nand: GPIO lookup for consumer rb
> > > omap2-nand 30000000.nand: using device tree for GPIO lookup
> > > of_get_named_gpiod_flags: parsed 'rb-gpios' property of node
> > > '/ocp at 68000000/gpmc at 6e000000/nand at 0,0[0]' - status (0)
> > > gpio gpiochip6: Persistence not supported for GPIO 0
> > > nand: device found, Manufacturer ID: 0x2c, Chip ID: 0xbc
> > > nand: Micron MT29F4G16ABBDA3W
> > > nand: 512 MiB, SLC, erase size: 128 KiB, page size: 2048, OOB size: 64
> > > nand: using OMAP_ECC_BCH8_CODE_HW_DETECTION_SW
> > > 6 cmdlinepart partitions found on MTD device omap2-nand.0
> > > Creating 6 MTD partitions on "omap2-nand.0":
> > > ...  
> >
> > Good to know. Can you just tell me if the values of
> > - chip->ecc.bytes vs. engine_conf->code_size
> > - chip->ecc.steps vs. engine_conf->nsteps
> > are the same in both cases (your patch and mine)? Otherwise your data
> > might appear corrupted somehow.  
> 
> I didn't fully vet my hack, beyond eliminating the Kernel panic, so I
> felt more comfortable comparing the values to a stable release.
> I compared the values in 5.10 to 5.11-rc4 + your patch, and the number
> of steps and oobregion->length are identical between them.
> 
> 5.10.5:
>   chip->ecc.steps = 4
>   oobregion->length = d
> 
> 5.11-rc4 + patch:
>   engine_conf->nsteps = 4
>   oobregion->length = d

Great, thanks for checking.

I'll send the formal patch then.

Thanks,
Miquèl