[PATCH 3/5] mtd: rawnand: qcom: Rename parameter name in macro

[Md Sadre Alam]

Rename the parameters of the nandc_set_read_loc() macro
to avoid the confusion between is_last_read_loc which
is last location in a read code word and last_cw which
is last code word of a page data.

Signed-off-by: Md Sadre Alam <mdalam at codeaurora.org>
---
 drivers/mtd/nand/raw/qcom_nandc.c | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/mtd/nand/raw/qcom_nandc.c b/drivers/mtd/nand/raw/qcom_nandc.c
index 9a890ef..f1aafee 100644
--- a/drivers/mtd/nand/raw/qcom_nandc.c
+++ b/drivers/mtd/nand/raw/qcom_nandc.c
@@ -181,11 +181,11 @@
 #define	ECC_BCH_4BIT	BIT(2)
 #define	ECC_BCH_8BIT	BIT(3)
 
-#define nandc_set_read_loc(chip, reg, offset, size, is_last)	\
+#define nandc_set_read_loc(chip, reg, cw_offset, read_size, is_last_read_loc)	\
 nandc_set_reg(chip, NAND_READ_LOCATION_##reg,			\
-	      ((offset) << READ_LOCATION_OFFSET) |		\
-	      ((size) << READ_LOCATION_SIZE) |			\
-	      ((is_last) << READ_LOCATION_LAST))
+	      ((cw_offset) << READ_LOCATION_OFFSET) |		\
+	      ((read_size) << READ_LOCATION_SIZE) |			\
+	      ((is_last_read_loc) << READ_LOCATION_LAST))
 
 /*
  * Returns the actual register address for all NAND_DEV_ registers
-- 
2.7.4