[PATCH v5 2/3] spi: dt-bindings: Describe stacked/parallel memories modes

Miquel Raynal miquel.raynal at bootlin.com
Tue Dec 21 09:00:57 PST 2021


Describe two new memories modes:
- A stacked mode when the bus is common but the address space extended
  with an additinals wires.
- A parallel mode with parallel busses accessing parallel flashes where
  the data is spread.

Signed-off-by: Miquel Raynal <miquel.raynal at bootlin.com>
---

Hello Rob,

I know the below does not pass the tests (at least the example patch 3
does not pass) but I believe the issue is probably on the tooling side
because the exact same thing with uing32-array instead is accepted. The
problem comes from the minItems/maxItems lines. Without them, this is
okay. The maxItems btw matches the "good enough value for now" idea.

The errors I get are:

$ make dt_binding_check DT_SCHEMA_FILES=Documentation/devicetree/bindings/spi/spi-controller.yaml
  LINT    Documentation/devicetree/bindings
  CHKDT   Documentation/devicetree/bindings/processed-schema-examples.json
  SCHEMA  Documentation/devicetree/bindings/processed-schema-examples.json
  DTEX    Documentation/devicetree/bindings/spi/spi-controller.example.dts
  DTC     Documentation/devicetree/bindings/spi/spi-controller.example.dt.yaml
  CHECK   Documentation/devicetree/bindings/spi/spi-controller.example.dt.yaml
/src/Documentation/devicetree/bindings/spi/spi-controller.example.dt.yaml: spi at 80010000: flash at 2:stacked-memories: [[268435456, 268435456]] is too short
	From schema: /src/Documentation/devicetree/bindings/spi/spi-controller.yaml
/src/Documentation/devicetree/bindings/spi/spi-controller.example.dt.yaml: spi at 80010000: flash at 2:stacked-memories: [[268435456, 268435456]] is too short
	From schema: /src/Documentation/devicetree/bindings/spi/mxs-spi.yaml
/src/Documentation/devicetree/bindings/spi/spi-controller.example.dt.yaml: spi at 80010000: Unevaluated properties are not allowed ('#address-cells', '#size-cells', 'display at 0', 'sensor at 1', 'flash at 2' were unexpected)
	From schema: /src/Documentation/devicetree/bindings/spi/mxs-spi.yaml
/src/Documentation/devicetree/bindings/spi/spi-controller.example.dt.yaml: flash at 2: stacked-memories: [[268435456, 268435456]] is too short
	From schema: /src/Documentation/devicetree/bindings/mtd/jedec,spi-nor.yaml


 .../bindings/spi/spi-peripheral-props.yaml    | 25 +++++++++++++++++++
 1 file changed, 25 insertions(+)

diff --git a/Documentation/devicetree/bindings/spi/spi-peripheral-props.yaml b/Documentation/devicetree/bindings/spi/spi-peripheral-props.yaml
index 5dd209206e88..fedb7ae98ff6 100644
--- a/Documentation/devicetree/bindings/spi/spi-peripheral-props.yaml
+++ b/Documentation/devicetree/bindings/spi/spi-peripheral-props.yaml
@@ -82,6 +82,31 @@ properties:
     description:
       Delay, in microseconds, after a write transfer.
 
+  stacked-memories:
+    description: Several SPI memories can be wired in stacked mode.
+      This basically means that either a device features several chip
+      selects, or that different devices must be seen as a single
+      bigger chip. This basically doubles (or more) the total address
+      space with only a single additional wire, while still needing
+      to repeat the commands when crossing a chip boundary. The size of
+      each chip should be provided as members of the array.
+    $ref: /schemas/types.yaml#/definitions/uint64-array
+    minItems: 2
+    maxItems: 4
+
+  parallel-memories:
+    description: Several SPI memories can be wired in parallel mode.
+      The devices are physically on a different buses but will always
+      act synchronously as each data word is spread across the
+      different memories (eg. even bits are stored in one memory, odd
+      bits in the other). This basically doubles the address space and
+      the throughput while greatly complexifying the wiring because as
+      many busses as devices must be wired. The size of each chip should
+      be provided as members of the array.
+    $ref: /schemas/types.yaml#/definitions/uint64-array
+    minItems: 2
+    maxItems: 4
+
 # The controller specific properties go here.
 allOf:
   - $ref: cdns,qspi-nor-peripheral-props.yaml#
-- 
2.27.0




More information about the linux-mtd mailing list