[PATCH v8 19/34] pwm: tegra: Add runtime PM and OPP support
Dmitry Osipenko
digetx at gmail.com
Mon Aug 16 18:27:39 PDT 2021
The PWM on Tegra belongs to the core power domain and we're going to
enable GENPD support for the core domain. Now PWM must be resumed using
runtime PM API in order to initialize the PWM power state. The PWM clock
rate must be changed using OPP API that will reconfigure the power domain
performance state in accordance to the rate. Add runtime PM and OPP
support to the PWM driver.
Signed-off-by: Dmitry Osipenko <digetx at gmail.com>
---
drivers/pwm/pwm-tegra.c | 104 ++++++++++++++++++++++++++++++++--------
1 file changed, 85 insertions(+), 19 deletions(-)
diff --git a/drivers/pwm/pwm-tegra.c b/drivers/pwm/pwm-tegra.c
index 11a10b575ace..bb6d184946b9 100644
--- a/drivers/pwm/pwm-tegra.c
+++ b/drivers/pwm/pwm-tegra.c
@@ -42,12 +42,16 @@
#include <linux/module.h>
#include <linux/of.h>
#include <linux/of_device.h>
+#include <linux/pm_opp.h>
#include <linux/pwm.h>
#include <linux/platform_device.h>
#include <linux/pinctrl/consumer.h>
+#include <linux/pm_runtime.h>
#include <linux/slab.h>
#include <linux/reset.h>
+#include <soc/tegra/common.h>
+
#define PWM_ENABLE (1 << 31)
#define PWM_DUTY_WIDTH 8
#define PWM_DUTY_SHIFT 16
@@ -145,12 +149,25 @@ static int tegra_pwm_config(struct pwm_chip *chip, struct pwm_device *pwm,
required_clk_rate =
(NSEC_PER_SEC / period_ns) << PWM_DUTY_WIDTH;
- err = clk_set_rate(pc->clk, required_clk_rate);
- if (err < 0)
+ /*
+ * GENPD performance state should be changed only for
+ * the resumed device because GENPD core tracks performance
+ * state and drops/restores the state on RPM suspend/resume.
+ */
+ err = pm_runtime_resume_and_get(pc->dev);
+ if (err)
+ return err;
+
+ err = dev_pm_opp_set_rate(pc->dev, required_clk_rate);
+ if (err < 0) {
+ pm_runtime_put(pc->dev);
return -EINVAL;
+ }
/* Store the new rate for further references */
pc->clk_rate = clk_get_rate(pc->clk);
+
+ pm_runtime_put(pc->dev);
}
rate = pc->clk_rate >> PWM_DUTY_WIDTH;
@@ -181,8 +198,8 @@ static int tegra_pwm_config(struct pwm_chip *chip, struct pwm_device *pwm,
* before writing the register. Otherwise, keep it enabled.
*/
if (!pwm_is_enabled(pwm)) {
- err = clk_prepare_enable(pc->clk);
- if (err < 0)
+ err = pm_runtime_resume_and_get(pc->dev);
+ if (err)
return err;
} else
val |= PWM_ENABLE;
@@ -193,7 +210,7 @@ static int tegra_pwm_config(struct pwm_chip *chip, struct pwm_device *pwm,
* If the PWM is not enabled, turn the clock off again to save power.
*/
if (!pwm_is_enabled(pwm))
- clk_disable_unprepare(pc->clk);
+ pm_runtime_put(pc->dev);
return 0;
}
@@ -204,8 +221,8 @@ static int tegra_pwm_enable(struct pwm_chip *chip, struct pwm_device *pwm)
int rc = 0;
u32 val;
- rc = clk_prepare_enable(pc->clk);
- if (rc < 0)
+ rc = pm_runtime_resume_and_get(pc->dev);
+ if (rc)
return rc;
val = pwm_readl(pc, pwm->hwpwm);
@@ -224,7 +241,7 @@ static void tegra_pwm_disable(struct pwm_chip *chip, struct pwm_device *pwm)
val &= ~PWM_ENABLE;
pwm_writel(pc, pwm->hwpwm, val);
- clk_disable_unprepare(pc->clk);
+ pm_runtime_put_sync(pc->dev);
}
static const struct pwm_ops tegra_pwm_ops = {
@@ -256,11 +273,21 @@ static int tegra_pwm_probe(struct platform_device *pdev)
if (IS_ERR(pwm->clk))
return PTR_ERR(pwm->clk);
+ ret = devm_tegra_core_dev_init_opp_table_simple(&pdev->dev);
+ if (ret)
+ return ret;
+
+ pm_runtime_enable(&pdev->dev);
+
+ ret = pm_runtime_resume_and_get(&pdev->dev);
+ if (ret)
+ goto disable_pm;
+
/* Set maximum frequency of the IP */
- ret = clk_set_rate(pwm->clk, pwm->soc->max_frequency);
+ ret = dev_pm_opp_set_rate(pwm->dev, pwm->soc->max_frequency);
if (ret < 0) {
dev_err(&pdev->dev, "Failed to set max frequency: %d\n", ret);
- return ret;
+ goto put_pm;
}
/*
@@ -278,7 +305,7 @@ static int tegra_pwm_probe(struct platform_device *pdev)
if (IS_ERR(pwm->rst)) {
ret = PTR_ERR(pwm->rst);
dev_err(&pdev->dev, "Reset control is not found: %d\n", ret);
- return ret;
+ goto put_pm;
}
reset_control_deassert(pwm->rst);
@@ -291,34 +318,70 @@ static int tegra_pwm_probe(struct platform_device *pdev)
if (ret < 0) {
dev_err(&pdev->dev, "pwmchip_add() failed: %d\n", ret);
reset_control_assert(pwm->rst);
- return ret;
+ goto put_pm;
}
+ pm_runtime_put(&pdev->dev);
+
return 0;
+put_pm:
+ pm_runtime_put(&pdev->dev);
+disable_pm:
+ pm_runtime_disable(&pdev->dev);
+ return ret;
}
static int tegra_pwm_remove(struct platform_device *pdev)
{
struct tegra_pwm_chip *pc = platform_get_drvdata(pdev);
+ int err;
pwmchip_remove(&pc->chip);
+ err = pm_runtime_resume_and_get(pc->dev);
+ if (err)
+ return err;
+
reset_control_assert(pc->rst);
+ pm_runtime_put(pc->dev);
+ pm_runtime_disable(pc->dev);
return 0;
}
-#ifdef CONFIG_PM_SLEEP
-static int tegra_pwm_suspend(struct device *dev)
+static int __maybe_unused tegra_pwm_runtime_suspend(struct device *dev)
{
- return pinctrl_pm_select_sleep_state(dev);
+ struct tegra_pwm_chip *pc = dev_get_drvdata(dev);
+ int err;
+
+ clk_disable_unprepare(pc->clk);
+
+ err = pinctrl_pm_select_sleep_state(dev);
+ if (err) {
+ clk_prepare_enable(pc->clk);
+ return err;
+ }
+
+ return 0;
}
-static int tegra_pwm_resume(struct device *dev)
+static int __maybe_unused tegra_pwm_runtime_resume(struct device *dev)
{
- return pinctrl_pm_select_default_state(dev);
+ struct tegra_pwm_chip *pc = dev_get_drvdata(dev);
+ int err;
+
+ err = pinctrl_pm_select_default_state(dev);
+ if (err)
+ return err;
+
+ err = clk_prepare_enable(pc->clk);
+ if (err) {
+ pinctrl_pm_select_sleep_state(dev);
+ return err;
+ }
+
+ return 0;
}
-#endif
static const struct tegra_pwm_soc tegra20_pwm_soc = {
.num_channels = 4,
@@ -344,7 +407,10 @@ static const struct of_device_id tegra_pwm_of_match[] = {
MODULE_DEVICE_TABLE(of, tegra_pwm_of_match);
static const struct dev_pm_ops tegra_pwm_pm_ops = {
- SET_SYSTEM_SLEEP_PM_OPS(tegra_pwm_suspend, tegra_pwm_resume)
+ SET_RUNTIME_PM_OPS(tegra_pwm_runtime_suspend, tegra_pwm_runtime_resume,
+ NULL)
+ SET_SYSTEM_SLEEP_PM_OPS(pm_runtime_force_suspend,
+ pm_runtime_force_resume)
};
static struct platform_driver tegra_pwm_driver = {
--
2.32.0
More information about the linux-mtd
mailing list