[PATCH v14 06/15] mtd: spi-nor: core: use dummy cycle and address width info from SFDP

[Pratyush Yadav]

The xSPI Profile 1.0 table specifies how many dummy cycles and address
bytes are needed for the Read Status Register command in octal DTR mode.
Use that information to send the correct Read SR command.

Signed-off-by: Pratyush Yadav <p.yadav at ti.com>
---
 drivers/mtd/spi-nor/core.c | 10 ++++++++++
 1 file changed, 10 insertions(+)

diff --git a/drivers/mtd/spi-nor/core.c b/drivers/mtd/spi-nor/core.c
index 97e82a4821f6..1465cf80f978 100644
--- a/drivers/mtd/spi-nor/core.c
+++ b/drivers/mtd/spi-nor/core.c
@@ -385,6 +385,11 @@ static int spi_nor_read_sr(struct spi_nor *nor, u8 *sr)
 				   SPI_MEM_OP_NO_DUMMY,
 				   SPI_MEM_OP_DATA_IN(1, sr, 0));
 
+		if (nor->reg_proto == SNOR_PROTO_8_8_8_DTR) {
+			op.addr.nbytes = nor->params->rdsr_addr_nbytes;
+			op.dummy.nbytes = nor->params->rdsr_dummy;
+		}
+
 		spi_nor_spimem_setup_op(nor, &op, nor->reg_proto);
 
 		ret = spi_mem_exec_op(nor->spimem, &op);
@@ -418,6 +423,11 @@ static int spi_nor_read_fsr(struct spi_nor *nor, u8 *fsr)
 				   SPI_MEM_OP_NO_DUMMY,
 				   SPI_MEM_OP_DATA_IN(1, fsr, 0));
 
+		if (nor->reg_proto == SNOR_PROTO_8_8_8_DTR) {
+			op.addr.nbytes = nor->params->rdsr_addr_nbytes;
+			op.dummy.nbytes = nor->params->rdsr_dummy;
+		}
+
 		spi_nor_spimem_setup_op(nor, &op, nor->reg_proto);
 
 		ret = spi_mem_exec_op(nor->spimem, &op);
-- 
2.28.0