R: [PATCH 2/2] dt: bindings: ath10k: Document qcom, ath10k-pre-calibration-data-mtd

[ansuelsmth at gmail.com]

> -----Messaggio originale-----
> Da: Christian Lamparter <chunkeey at gmail.com>
> Inviato: venerdì 18 settembre 2020 18:54
> A: Ansuel Smith <ansuelsmth at gmail.com>; Kalle Valo
> <kvalo at codeaurora.org>
> Cc: devicetree at vger.kernel.org; netdev at vger.kernel.org; linux-
> wireless at vger.kernel.org; linux-kernel at vger.kernel.org;
> ath10k at lists.infradead.org; David S. Miller <davem at davemloft.net>; Rob
> Herring <robh+dt at kernel.org>; Jakub Kicinski <kuba at kernel.org>; linux-
> mtd at lists.infradead.org; Srinivas Kandagatla
> <srinivas.kandagatla at linaro.org>; Bartosz Golaszewski
> <bgolaszewski at baylibre.com>
> Oggetto: Re: [PATCH 2/2] dt: bindings: ath10k: Document qcom, ath10k-
> pre-calibration-data-mtd
> 
> On 2020-09-18 18:29, Ansuel Smith wrote:
> > Document use of qcom,ath10k-pre-calibration-data-mtd bindings used to
> > define from where the driver will load the pre-cal data in the defined
> > mtd partition.
> >
> > Signed-off-by: Ansuel Smith <ansuelsmth at gmail.com>
> 
> Q: Doesn't mtd now come with nvmem support from the get go? So
> the MAC-Addresses and pre-caldata could be specified as a
> nvmem-node in the devicetree? I remember seeing that this was
> worked on or was this mtd->nvmem dropped?
> 
> Cheers,
> Christian

Sorry a lot for the double email... I think I found what you are talking about.
It looks like the code was merged but not the documentation.
Will do some test and check if this works.

This should be the related patch.
https://patchwork.ozlabs.org/project/linux-mtd/patch/1521933899-362-4-git-send-email-albeu@free.fr/