[PATCH 0/5] mtd: rawnand: qcom: Add support for QSPI nand

[Md Sadre Alam]

QPIC 2.0 supports Serial NAND support in addition to all features and
commands in QPIC 1.0 for parallel NAND. Parallel and Serial NAND cannot
operate simultaneously. QSPI nand devices will connect to QPIC IO_MACRO
block of QPIC controller. There is a separate IO_MACRO clock for IO_MACRO
block. Default IO_MACRO block divide the input clock by 4. so if IO_MACRO
input clock is 320MHz then on bus it will be 80MHz, so QSPI nand device
should also support this frequency.

QPIC provides 4 data pins to QSPI nand. In standard SPI mode (x1 mode) data
transfer will occur on only 2 pins one pin for Serial data in and one for
serial data out. In QUAD SPI mode (x4 mode) data transfer will occur at all
the four data lines. QPIC controller supports command for x1 mode and x4 mode.

Md Sadre Alam (5):
  dt-bindings: qcom_nandc: IPQ5018 QPIC NAND documentation
  mtd: rawnand: qcom: Add initial support for qspi nand
  mtd: rawnand: qcom: Read QPIC version
  mtd: rawnand: qcom: Enable support for erase,read & write for serial
    nand.
  mtd: rawnand: qcom: Add support for serial training.

 .../devicetree/bindings/mtd/qcom_nandc.txt         |   3 +
 drivers/mtd/nand/raw/nand_ids.c                    |  13 +
 drivers/mtd/nand/raw/qcom_nandc.c                  | 502 ++++++++++++++++++++-
 3 files changed, 494 insertions(+), 24 deletions(-)

-- 
2.7.4