[PATCH v2] mtd: spi-nor: Fix address width on flash chips > 16MB
Cédric Le Goater
clg at kaod.org
Wed Oct 7 01:44:54 EDT 2020
On 10/7/20 3:51 AM, Joel Stanley wrote:
> On Sun, 4 Oct 2020 at 21:33, Bert Vermeulen <bert at biot.com> wrote:
>>
>> If a flash chip has more than 16MB capacity but its BFPT reports
>> BFPT_DWORD1_ADDRESS_BYTES_3_OR_4, the spi-nor framework defaults to 3.
>>
>> The check in spi_nor_set_addr_width() doesn't catch it because addr_width
>> did get set. This fixes that check.
>>
>> Signed-off-by: Bert Vermeulen <bert at biot.com>
>
> After replying to the other thread, I just saw this one.
>
> Reviewed-by: Joel Stanley <joel at jms.id.au>
> Tested-by: Joel Stanley <joel at jms.id.au>
>
> Thanks Bert!
Yes. I was starting to add bfpt-fixups for all chips we use on Aspeed
based system.
Reviewed-by: Cédric Le Goater <clg at kaod.org>
Tested-by: Cédric Le Goater <clg at kaod.org>
Thanks,
C.
> Cheers,
>
> Joel
>
>> ---
>> drivers/mtd/spi-nor/core.c | 8 +++++---
>> 1 file changed, 5 insertions(+), 3 deletions(-)
>>
>> diff --git a/drivers/mtd/spi-nor/core.c b/drivers/mtd/spi-nor/core.c
>> index 0369d98b2d12..a2c35ad9645c 100644
>> --- a/drivers/mtd/spi-nor/core.c
>> +++ b/drivers/mtd/spi-nor/core.c
>> @@ -3009,13 +3009,15 @@ static int spi_nor_set_addr_width(struct spi_nor *nor)
>> /* already configured from SFDP */
>> } else if (nor->info->addr_width) {
>> nor->addr_width = nor->info->addr_width;
>> - } else if (nor->mtd.size > 0x1000000) {
>> - /* enable 4-byte addressing if the device exceeds 16MiB */
>> - nor->addr_width = 4;
>> } else {
>> nor->addr_width = 3;
>> }
>>
>> + if (nor->addr_width == 3 && nor->mtd.size > 0x1000000) {
>> + /* enable 4-byte addressing if the device exceeds 16MiB */
>> + nor->addr_width = 4;
>> + }
>> +
>> if (nor->addr_width > SPI_NOR_MAX_ADDR_WIDTH) {
>> dev_dbg(nor->dev, "address width is too large: %u\n",
>> nor->addr_width);
>> --
>> 2.17.1
>>
More information about the linux-mtd
mailing list